Electronics Forum | Mon Nov 09 22:25:04 EST 2020 | compit
I don't know about here, but in YV100 the drive is on ATA PCMCIA flashdisk. Maybe it is underpressed / damaged? Or after replacing the battery on mainboard, you need to enter its parameters in the BIOS.
Electronics Forum | Wed Mar 24 15:55:48 EDT 2021 | grahamcooper22
Hi, what is the criteria for when you need to implement SPI after the paste printing process ?
Electronics Forum | Fri May 14 14:44:06 EDT 2021 | dontfeedphils
If you add a FIFO buffer after reflow and before AOI you can avoid boards piling up in reflow and give yourself some wiggle room on cycle time mismatches between pick and place and AOI.
Electronics Forum | Mon May 31 09:47:57 EDT 2021 | fujipro
Sorry, no chance to check the IPS on AHC without the necessary Jigs and the knowledge. 7F12 is typical errorcode for a poorly connected Ribbon cable on the LED Board. If this error still occurs after reconnected the LED Board is may broken. If needed
Electronics Forum | Wed Jun 16 12:36:32 EDT 2021 | bukas
do you have a HDD backup? I often had a problem with HDD after a longer pauses.
Electronics Forum | Fri Jun 18 10:07:46 EDT 2021 | bukas
have you tried HDD restore jet? another thing, two ovens with same malfunction after period of not being used sounds much like bad electrolytic capacitors... how old are the machines?
Electronics Forum | Tue Sep 07 15:23:20 EDT 2021 | majdi4
1 ) Component is not Rohs : Material analyzes confirm that they contain lead over than < 1000ppm 2 ) upper piston blocked after reflow 3 ) wetting was unstable and slow due to heat transfer will you produce with ??
Electronics Forum | Fri Sep 10 01:11:32 EDT 2021 | Ran
Slanting Issues after reflow if u are using thru-hole type, u might need to define the slanting degree allowed during prototype. =)
Electronics Forum | Wed Sep 22 14:22:54 EDT 2021 | oclsc
Hi Forum. Is there anyone who can tell if an empty PCB with no SMD components mounted and HAL surface will get a less solderability after been running through reflow (convection). Eg. when testing empty PCB with temperture data logger. Regards Ole
Electronics Forum | Wed Sep 22 17:14:49 EDT 2021 | swilson
Hello while washing SMT boards can unsealed switches and transformers be washed and/or will the wash solution damage the component down the road? Normally I leave them off and add them after wash just want to know if there is anyway possible to get t