Electronics Forum | Mon Aug 23 10:11:55 EDT 2010 | flipit
Hi, I have never been able to find an acceptable dispense process for dispensing small dots of solder paste. I currently have an auger screw automated dispense system and can not accomplish 0.010" dot sizes. In addition, stencil printing is much m
Electronics Forum | Thu Feb 10 10:49:26 EST 2000 | Sal
The connectors are well within thier specification,and are also checked for misaligned and damaged pins , as regards the cross-section results, all holes are correctly aligned and are well spaced within their tolerance of +/-0.005 (a couple of isolat
Electronics Forum | Thu Jun 15 12:57:12 EDT 2000 | Dave F
0.0006" LT Total pad height = Thickness of ( Copper pad + OSP ) = 0.0014" + 0.00000157" = ~0.0014" (You must be using an organic solderability preservative (OSP) or Electroless Nickel immersion gold (ENIG) because 0.003" tin/lead or white tin would
Electronics Forum | Tue Aug 21 05:05:52 EDT 2007 | vangogh
Hi All, I would like to get some inputs regarding this.... I have bare PCB which were stored with kapton tape attached on the Au plated pads. These were stored for close to a year. Upon removal of kapton tape, we noticed discolorations on the edges o
Electronics Forum | Fri Dec 07 15:12:56 EST 2007 | teodor
Hello , I would like to collect your valued opinions what is better for beggining . Samsung CP-45NEO Juki 2060 Light Feeder Positions (8 mm) 104 80 PCB Size (min - max) 50x30-460x400 mm 50x30-410x360 m
Electronics Forum | Tue Jan 04 09:26:22 EST 2011 | scottp
We've been doing this for over 10 years using flux. We print a tacky flux first using an 0.002 or 0.003" thick stencil, then print paste using a thicker stencil with the underside half etched to keep it away from the flux. In our case, we can't jus
Electronics Forum | Mon Jun 11 17:14:13 EDT 2012 | mmjm_1099
1st Question I am working on ROI for a bare board destacker and wondering if anyone has a general guideline to follow. Example of ROI for bare board destacker I have now as follows: $7500 for destacker, Avg panel input 3365, Time to load in panel 7
Electronics Forum | Mon Feb 22 12:04:15 EST 1999 | Dave F
| Please could you suggest a recommended aperture sizes for | printing of smd adhesives. Any recommendations on stencil thickness as well as stencil finish will be appreciated. | Mark: About the only rule of printing adhesives is: Keep it off the
Electronics Forum | Tue Aug 27 22:07:45 EDT 2002 | davef
Pad. Land. A portion of a conductive pattern used as a termination area. Metal surrounding a hole on a printed circuit board. Mask. A material applied to allow selective etching, plating, or protection of the surface of a printed circuit board.
Electronics Forum | Wed May 18 14:58:05 EDT 2005 | splice
Hi, I am having some PTH non wetting issues. Setup and chronology of events is explained: Set Up; Part: 1 MM pitch connector 378 pins Solder: Kester Ultra Pure 63/37 solder Pot; 250 C pre heat; Peak 94C top side Flux: Qualitek 775, Fluxer: foam T