Electronics Forum | Sun Jan 10 16:07:01 EST 2010 | propox
Hello I have guestion, we bought two topaz and emerald machines. We have a problem to make a pick and place files to this machines. Recently we were useing CSM-84VZ. Do You have any help for us? Thank You.
Electronics Forum | Sun May 16 00:07:58 EDT 2010 | tpappano
I have a Philips CSM84VZ. There are offset calibrations that compensate the X and Y distances from the camera to the heads and the beam pointer. Perhaps yours is similar and just needs a small Y adjustment for the beam pointer.
Electronics Forum | Wed May 26 11:16:52 EDT 2010 | tpappano
Hello All, I need this part for my CSM84VZ if anyone has one or an idea who might. It is a "HI-T" DC servo-actuator, part# RH-8-6006-E100DO. Thanks
Electronics Forum | Thu Dec 09 02:11:18 EST 2010 | tpappano
Hi All, I have recently acquired another CSM84VZ, which will soon need the Y-axis ball screw replaced. Would anyone happen to know the ball screw mfr. and series that would best fit this machine? Thanks, Tom
Electronics Forum | Fri Jan 07 06:39:10 EST 2011 | jeffr
David, Oops, I made a mistake on that phone number... Should be +61-417386694. (Code 61 is correct for Australia). Regards Jeff
Electronics Forum | Fri Jan 07 11:08:08 EST 2011 | tpappano
Follow that same link I gave you for the sample files, there is a zip of a file transfer utility specifically for these machines. (I sent you an email, too) Enjoy, Tom
Electronics Forum | Fri Jan 07 12:01:29 EST 2011 | ercdave1
Tom, I got the the files, now i will make the cable and try it out. did you find the floppy drive in your machine? Thanks for the help David
Electronics Forum | Fri Jan 07 12:32:03 EST 2011 | tpappano
I'm just now headed for the shop, I'll take a look. Tom
Electronics Forum | Thu Jan 20 19:13:15 EST 2011 | jeffr
You should check that the machine actually works before you buy it. I still can purchase most parts, but the Vision Board is not available anymore.
Electronics Forum | Wed Nov 02 00:48:05 EDT 2011 | tpappano
Thanks for the reply, all the parameters are being entered, but there is something subtle causing the error messages, likely some silly thing I'm overlooking. Hopefully someone is familiar with these error messages, because the manual hasn't been mu