Electronics Forum | Thu Jul 19 08:33:37 EDT 2007 | allgood
Ok I can get into the service program - under Motors there is only a single X motor listed. And what test can you do - seems that I can only display ranges and settings? No test as such?
Electronics Forum | Wed Jun 27 14:36:22 EDT 2012 | cyber_wolf
If the X axis is moving then maybe your Elmo is not adjusted correctly. There is a procedure to adjust it in the manual(assuming you have the original manual). The correct location is XGTS which is a white connector on the booster. The fans are 24V
Electronics Forum | Tue May 21 13:38:04 EDT 2013 | CJTech2X
Anyone know a good North American source for Assembleon feeders? Specifically 24mm with a 12mm+ depth? Also looking for 16mm, 12mm, 32mm, and 44mm.
Electronics Forum | Fri Oct 26 19:53:48 EDT 2018 | sarason
Suck it and see, start at a 3V pulse, then a 5V pulse, then a 12V pulse, time is not likely to be that critical but a few milliseconds should do! sarason
Electronics Forum | Thu Oct 17 13:59:58 EDT 2019 | mendezt6
Trying to install A12 tool, fails to fetch tool. Error: Preliminary fetch failed, try to unlock tool manually.
Electronics Forum | Tue Jul 17 11:15:05 EDT 2007 | allgood
We keep seeing a problem with the plastic tool tip on an A12 tool being sliced off. I think it is hitting the edge of the tape separator clip assembly - I determined this by coating the tip in paint and then finding where the tip had struck the meta
Electronics Forum | Wed Dec 02 05:20:57 EST 1998 | Jim Mitchell
Quad still sells a low end convection/IR bench top oven for about $15,000. (ZCR 412B) It is limited to a 12" board but may work for your application. IR ovens have gone out of favor recently. There should be some older IR ovens for under $5,000 f
Electronics Forum | Mon Sep 17 08:40:04 EDT 2001 | dave_bond
I have done a search of the Forum and didn't really see what I was looking for. We could be doing a 12" x 10" x .060" single sided ceramic PCB with all surface mount devices. Are there any "secerts" or "things to watch out for" when processing cerami
Electronics Forum | Tue Mar 11 09:26:36 EST 2003 | jseagle
Dave, Not sure if I understand the question. We do not process No-Clean in our facility at the current time. We are a completely Water-Soluble with a 12 year old Hollis Polyclean In-Line washer. I need to scrap the piece of ****. That's another
Electronics Forum | Fri Sep 19 17:48:43 EDT 2003 | russ
Hoss, here is what we do, we start with a 12-24 hr. at 100C. and then test. Sometimes it takes longer and sometimes you could probably get away with 8 hours. You could increase the temp to shorten but I would not go above 375 deg. F however. Hope