Electronics Forum | Fri May 09 09:52:33 EDT 2014 | aj
http://www.murata.com/products/micromechatronics/feature/actuator/index.html not much info out there about them - will contact supplier but interested to know if anyone works with these .
Electronics Forum | Wed Oct 29 18:08:35 EDT 2014 | tombstonesmt
Good afternoon. Not sure if this is available at an engineer level. Perhaps and SD card with field service access is necessary. We have two lines with NPM-W's and the most we've been able to do is actuate vacuum on the heads during flow checks.
Electronics Forum | Fri Apr 17 06:42:01 EDT 2015 | cspasol
Thank you for the information. I will check the on Linak if I can find what i'm looking for.
Electronics Forum | Thu Mar 25 11:19:11 EST 2004 | paul_bmc
Thanks for the informative posting.. When I power up the machine this is what I get.. 1. The movable cutter does not actuate the cutter knifes. (The head still jogs 360 and the movable cutter moves in the linear axis but the c&c motor does not act
Electronics Forum | Thu Jan 13 15:17:27 EST 2022 | goseese
Thank you very much I will look for something moving, loose or getting pinched when the table moves. -- Update -- checked every single connector, all the purple cables/connectors too. Everything it tight and not getting hung up. Checked all the
Electronics Forum | Fri Aug 04 09:48:37 EDT 2023 | boyabandaoti
The pneumatic control valve can be roughly divided into different valves: pneumatic ball valve, pneumatic butterfly valve, pneumatic gates valve, pneumatic intercept valve, and so on. The first two are switching methods of angle strokes, and the latt
Electronics Forum | Mon Nov 30 10:04:26 EST 1998 | Clint Hardee
Yes, the GEM series feeders are quite different. In fact, if you put CSM feeders on a GEM machine, you will probably break nozzles and crash the head due to the fact that the CSM feeders have a mechanical arm that sticks up toward the front of the bo
Electronics Forum | Wed May 08 10:05:42 EDT 2002 | Claude_Couture
Maybe the problem is not the cutter, but the arm that advance the tape in the adjacent feeder gets actuated at the same time as the active feeder. line-up a feeder in pickup position visually, then turn the crank until the roller or feeder advance me
Electronics Forum | Fri Jul 12 12:04:51 EDT 2002 | jax
The Lizard Tongue is just a thin metal strip that, when actuated, slides over the BGA component and holds it down during transport. If you contact FUJI, they should be able to give you a part number, and install instructions..... maybe even the real
Electronics Forum | Sat Oct 21 03:02:02 EDT 2006 | aj
All, We had a power cut the today. Machine times out on Actuators and Paste Dispenser hence it will not Initialise fully. I have traced back each related card but all seem to check out fine. Next step is PSU (looks awkward to access) Any ideas fe