Electronics Forum | Tue Jun 12 11:10:08 EDT 2012 | dyoungquist
We run 1 high mix/low volume line using a MY12 with the MyLabel and MyPlan software. The MyLabel software helps reduce setup times while tracking quantities on the reels and is well worth the investment in our opinion. As for needing extra reels on
Electronics Forum | Thu May 18 07:37:06 EDT 2017 | stephendo
I have just been asked to project manage the > introduction of new production line within my > organisation . This normally wouldn't be a > problem but I have very little experience on smt > manufacturing. I guess the hard part is done as > all
Electronics Forum | Tue May 16 02:12:58 EDT 2017 | robl
Hi Anthony, Hopefully some of the following may help: 1) Electrics - do you know the rating of each machine and the total load, and can your distribution box take it? Do you have the correct cabling and connectors in place to just plug the machines
Electronics Forum | Mon Oct 28 21:17:40 EDT 2019 | sarason
The OCD in me suggests you chase down Windows Time/Date configuration ,also when you power up the machine check the time/date in the BIOS I presume these machines are windows based just looking in the Assembleon website. sarason
Electronics Forum | Fri Nov 12 08:26:02 EST 2010 | AL
Guys, Any feedback about getting in line solder paste inspection equipment vs of line equipment (off line sampling).
Electronics Forum | Tue Nov 03 20:28:33 EST 2020 | williamrobbins
Yes, it is most likely the BIOS and Windows Time configuration. If you are familiar with how to switch to Windows Operating system mode and back it can be checked. Our displayed times are off but in ASM trace service the times are all accurate so I d
Electronics Forum | Tue Sep 14 16:45:20 EDT 1999 | Wendy Casker
Hey all, Just got a new PC whiz bang everything but the kitchen sink, and my Quad Gui software can't run on it. I keep getting insufficient memery errors. Any Windows gurus out there who can help? I can't figure out how to allocate the memory to m
Electronics Forum | Thu May 26 12:21:04 EDT 2005 | stepheniii
We have dek-my12-my12-heller. We are very happy with it. Change-over time varies more by facility than by machine type. I worked at a place with dek-mviif-msf-btu and we had faster changeovers there. There we had a dedicated feeder set-up. Close to
Electronics Forum | Wed May 20 16:07:22 EDT 2020 | stephendo
You want a big enough storage tank to smooth pressure. Figure out what size pipes you need and go a size bigger. Make a loop of the pipes with shut offs. That way you can shut down any section and still have air to the rest of the air line. Run the p
Electronics Forum | Tue Nov 30 07:53:54 EST 2021 | saberbouras
I suggest that you perform a electric power quality analysis with a qualified technician using this equipment https://www.fluke.com/en-us/product/electrical-testing/power-quality/1742-1746-1748 test 1 : all lights on take the measurement of your s
