Electronics Forum | Tue Feb 28 07:47:33 EST 2006 | davef
The key driver to aperture design is to assure a fillet of the proper height for the component temination and the reliability of the end-product customer use environment.
Electronics Forum | Wed Aug 16 13:31:30 EDT 2006 | a_laser
You can stop cleaning after a job when there is no more paste in the apertures. Under wiping should be done with a quality cloth and should leave no paste on the underside of the stencil (assures good contact on the next print and reduces chances of
Electronics Forum | Mon Nov 27 13:18:07 EST 2006 | jay
As an OEM, I would like to refer to a shipping standard for completly assembled and tested PCA. These are going to be shipped to me from Mexico and I want to assure they are packed and protected properly. Is there a standard that I can refer to?
Electronics Forum | Wed Dec 20 16:50:26 EST 2006 | stepheniii
I worked for a company that had a nurse come in to talk to us about lead exposure. She assured us we had nothing in facility that would come close to vapourizing lead. Are you sure they didn't touch up using leadfree solder?
Electronics Forum | Fri Apr 11 15:30:42 EDT 2008 | hussman
How do you assure your operator follows this math? Our operators can't even pull their pants all the way up or wear their hats on straight.
Electronics Forum | Tue May 06 22:21:38 EDT 2008 | davef
It's prudent to rattle on about proper hygene and safe handling to remind our troop that they need to be careful not to take-on lead through hand-to-mouth action. What steps do you take to assure that your troop are not taking on lead as an unintende
Electronics Forum | Mon May 26 09:31:41 EDT 2008 | davef
What steps are taken in low residue wave soldering to assure the proper amount of flux is applied prior to soldering? * Too little flux can result in poor solder flow. * Too much flux can result in corrosive residues left on the board after soldering
Electronics Forum | Thu Aug 30 22:03:40 EDT 2012 | davef
How about this ... If your customer plans to provide the BOM on media that could be affected by magnetic fields, might the customer want to be assured that you have an established process to the protect that media from magnetic fields?
Electronics Forum | Sun Dec 08 09:59:39 EST 2013 | davef
Component fabricator is concerned about the temperature of the lead at the point where the lead enters the component body. So, if you sink temperature at that point, you will assure a lower chance of damaging the component.
Electronics Forum | Sat Jun 20 19:12:31 EDT 2015 | se_aaron
Have you heard about Smart Electronics UK. They assure UK quality and extremely quick service. Also they support with components sourcing and stocking for future orders.
