Electronics Forum | Mon Jan 10 17:07:51 EST 2022 | goldendragon
Hello Team, Do you have belts for these PCT WS1010 and PCT CV1010? Appreciates!
Electronics Forum | Tue Aug 01 09:38:46 EDT 2023 | jbrochecouste
hello all, I need the reference or caracteristics of locking belt on SPEA 4060, thx
Electronics Forum | Tue Dec 16 16:14:20 EST 2003 | Bill
We are in need of a replacement conveyor belt for an unload-end conveyor(post wave solder). The part number we had at one point (formerly PCT automation) was 65-4008-4 (Belt, Flat-W=23.75 L=171.70) green high temp conveyor belt. Any help would be g
Electronics Forum | Thu Mar 04 12:49:56 EST 2004 | haviland
Good morning. We have available several decline and several flat bed belt style exit conveyors, including a couple w/ cool down fans above the belt, e.g., a Kanetic48" OAL w/ 18" wide belt plus (8) fans priced at $1,000.00 FOB IL.
Electronics Forum | Sat Mar 25 16:36:44 EST 2006 | Frank
Comtra doesn't usually sell directly to the end user. Try consulting your machine manufacturer. On the mechanical belt feeders there are no adjustment. On the electrical feeders there is a turn switch to select the feeding travel of the belt. T
Electronics Forum | Tue Feb 17 13:04:14 EST 2015 | longnguyen
I am looking for the Manual and the Conveyor belt fluid cleaner for the Electrovert Bravo 8105, the conveyor belt fluid container is near the front with the brush point down to belt ( closed to the monitor ), any one know where can i buy this Manual
Electronics Forum | Mon May 18 14:46:38 EDT 2020 | dnachristen
Hello, We are looking for sources to keep our old Comtra Belt Feeders going for our Assembleon equipment. Mainly the belts that transport the component forward. Comtra went out of business years ago and parts are no longer available. I'm just looki
Electronics Forum | Fri Feb 11 20:16:43 EST 2022 | mihai_voivod
Hi guys, This stubborn conveyor (inline smt 1m 2 stage) keeps popping off its track. I have tried to replace the old belt, turn the new belt around, tighten it as much as I can, but it keeps coming off the little wheels as shown in the picture. D
Electronics Forum | Tue Feb 15 03:56:18 EST 2022 | cbeneat
Is the wheel that drives the belt in alignment? I assume all the bearings are turning. We've had bearings in the past be on the edge of seizing in our end pulley's. Tightening too much could cause it to turn harder, causing the belt to jump off. Coul
Electronics Forum | Wed Dec 17 13:04:37 EST 2003 | Bill
Thanks for the information, --We would like to replace the conveyor 'belt' rather than replace the whole conveyor. Do you know of any sources for the belting material? (ESD, heat and chemical resistant) Best Regards, Bill