Electronics Forum | Tue Jun 08 13:06:53 EDT 1999 | Kevin Hussey
| | Hi,my master | | How to iron out such soldering bridge with below conditions: | | 1.The component(Harness)lead pitch is 2.0mm,the lead length is 3.2mm. | | 2.PCB width is 1.6mm.Pad size is 1.65mm.Its a single copper PCB | | 3.using spraying fl
Electronics Forum | Wed Jul 14 16:59:52 EDT 2010 | swag
Solder paste on the pads will keep part aligned. If you do not use paste, you will need to apply tacky flux. You should not run without one or the other.
Electronics Forum | Thu Feb 26 13:29:36 EST 2015 | swiese242
Use the appropriate heat for that part. You can then use techspray flux remover with a brush. Spray the brush, and not the board, to reduce spreading the flux. Acetone or alcohol are less expensive and may work as well.
Electronics Forum | Thu Mar 20 13:22:27 EST 2003 | bmaheu
James, I've done some extensive studies cleaning BGA's while I was employeed by one the companies you are considering. In an attempt to avoid being commercial I will use general statments to address your question(s). The key to cleaning underneath
Electronics Forum | Mon Mar 15 09:14:26 EST 1999 | Todd N
Does anyone have any recommendations on spray fluxers? Are there major differences between the high priced ultrasonic machines to the low priced flux/air spraying machines? We are going to be spraying an OA flux with 11% solids content. Are there any
Electronics Forum | Tue Mar 16 13:49:21 EST 1999 | Steve Skinner
| Does anyone have any recommendations on spray fluxers? Are there major differences between the high priced ultrasonic machines to the low priced flux/air spraying machines? We are going to be spraying an OA flux with 11% solids content. Are there a
Electronics Forum | Fri Apr 05 15:25:14 EST 2002 | davef
Spray fluxers: Where does the excess flux [that does not glomb on the board] go after being sprayed at the board? How do various spray fluxers [wave solder machines] route �used flux� differently?
Electronics Forum | Thu Jan 11 09:53:14 EST 2001 | Peter Barton
What type of spray fluxing system are you trying to implement?
Electronics Forum | Thu Aug 04 12:58:01 EDT 2022 | SMTA-68235204
looking for some recommendations on spray flux systems.
Electronics Forum | Mon Mar 15 20:13:10 EST 1999 | Wayne Bracy
| Does anyone have any recommendations on spray fluxers? Are there major differences between the high priced ultrasonic machines to the low priced flux/air spraying machines? We are going to be spraying an OA flux with 11% solids content. Are there a