Electronics Forum | Wed May 24 21:58:12 EDT 2006 | KEN
I have 4 of these furnaces. Give me your length, width, mass (grams) and I'll run this through our system and get you close.
Electronics Forum | Fri May 26 03:44:34 EDT 2006 | geb
Thank you - The PCB weighs 192.9g and is 314mm x 228mm. Not very densly populated.
Electronics Forum | Fri May 26 10:36:07 EDT 2006 | geb
Cheers Samir, that was a great help! I've tweaked the settings a bit to suit our PCB and it works well. Thanks again.
Electronics Forum | Fri Dec 22 09:47:18 EST 2006 | realchunks
Check your battery back up if you have it. If I remember correctly, you may have to manually switch your wiring to by pass a dead battery back-up.
Electronics Forum | Sat Dec 30 00:24:41 EST 2006 | Lars
Of course there are a way to fix your problem. What is Your problem in detail after checking out all the previous "so called" experts? (No offends to you guys at SmtNet.com).
Electronics Forum | Thu Jan 04 11:53:29 EST 2007 | samir
Hey Chunks, Come APEX time, I'd like to see your, uhm, "credentials" (*(wink* *wink*). Of course we still need to hit that Karaoke bar!
Electronics Forum | Wed Nov 12 11:19:15 EST 2008 | davef
Consider calling used equipment suppliers. Often, they keep the manuals for equipment in a "library" because they're unsure if they will get a manual with the next piece of that equipment they buy to resell. So then, they can make a copy to go with t
Electronics Forum | Fri Sep 07 09:25:22 EDT 2012 | donkudner
We are planning to purchase two new reflow ovens. I would like to take an unofficial reliability survey. Could you list your reflow oven model / age (yrs) / number of unplanned maintenance events in the last year? Example: BTU VIP98/2001/8
Electronics Forum | Wed May 24 13:10:28 EDT 2006 | Chunks
VIP 98, I believe that's a 7 zone if I can remember 6 years ago. Try 150, 165, 200, 235, 235 and 235 (top and bottom temps) with a belt speed of 35 inches per minute. This should get you in the ball park depending on the size of your board.
Electronics Forum | Mon Aug 27 12:33:46 EDT 2007 | emilio1
Hello everyone; I was wondering if anyone has/knows where to get, VIP98 FCU calibration procedure. I know its a long shot but need to calibrate a few ovens and we�d like to see if its possible to do this in house, as we have a calibration lab.