Electronics Forum | Thu Sep 02 04:59:17 EDT 2010 | sachu_70
Feeder calibration helps to center the window opening used during component pick-up by a machine nozzle. Once this is established, the next step would be to confirm the centering of Machine nozzle to the center of this feeder window during machine op
Electronics Forum | Wed Mar 03 04:26:58 EST 2004 | Evtimov
Hi Chris, About marks detect: If you have vision system you can recognize the fids and not center them manual. If only camera you have to put the center of the camera in the center of the mark.
Electronics Forum | Mon Jul 10 14:40:41 EDT 2006 | Billy D
Dude - check the centering jaws as well. If they're off a bit it'll do this as well. Is it just mechanically centered parts, or optically centered parts also?
Electronics Forum | Tue Jan 16 02:31:19 EST 2007 | meritajs
The problem is that if we disable center head and even turn off the cable of center head encoder, it's not helps. The same error appears. And it's all the same it shows error of the center head.
Electronics Forum | Mon Jun 24 13:01:24 EDT 2013 | quaker332007
Can anyone help me with the center support on this oven? The support is rising up to high and causing the board to rock during reflow. Is the away to lower the center support?
Electronics Forum | Mon Sep 23 14:26:27 EDT 2013 | joekirin
On machines such as MyDatas you have the ability to mechanically center parts rather than optically centering. If your machine is capable of doing mechanical centering that would eliminate the need for the vision analysis. -Joe
Electronics Forum | Fri Aug 01 09:21:28 EDT 2014 | jimmyboz
Does it error during nozzle center check, if so, manually switch all holders to small, try center again. It should do about 8 small nozzle centers before error, if so this helps rule out the 10th station, if not check the 10th.
Electronics Forum | Fri Nov 20 09:32:35 EST 2020 | artem
Hello, I have fixed the issues with the centering. Below the centering head there is a adjustment screw. First you have to remote a few screws to get access to it. They you can turn the adjustment screw to align the centering jaws.
Electronics Forum | Thu Jan 28 14:23:25 EST 2021 | davef
Consider posting your job opening in the "Career Center [ https://smtnet.com/career_center/index.cfm?fuseaction=add_job ] on SMTnet. Look in the blue-colored navbar over in the left margin for the "Career Center."
Electronics Forum | Mon May 08 18:13:59 EDT 2023 | joekirin
Do you have an optical centering phase active for centering? You can have hydra tools setup in the package but if there is no optical centering it wont use the hydra.
