Electronics Forum | Thu Jun 02 14:50:41 EDT 2005 | techknow..
Placement looks good...paste to pad coverage good..correct profile used and verified by tracker. The problem being that this one cap is tombstoning at the same place every time. The placement is central. The part is near the edge at the break off.
Electronics Forum | Sat May 05 21:26:31 EDT 2007 | bkgsmtnet
Who services your MYDATA machines? Do you have to have your software registered to get service? Are there independent field service techs out there? thx b
Electronics Forum | Sun May 06 14:46:27 EDT 2007 | grantp
Hi, We just had our local distributor do it for us, and they had a tech. Grant
Electronics Forum | Fri May 11 10:01:25 EDT 2007 | bkgsmtnet
In your experience how is MYDATA tech support? What do they charge? How is their response time? Do you have to register with them in order to get service? (i hear you have to register your software for apprx. $3500)
Electronics Forum | Wed Oct 08 14:30:42 EDT 2008 | leemeyer
Was the board programmed using Autoprogram or did you hand program it? What version of Central Controller are you running.
Electronics Forum | Wed Oct 08 15:46:41 EDT 2008 | bobpan
ok....couple of other questions first......does your machine say MVS when entering into central controller? After you teach your fiducials...Are you entering out of the screen....if you hit escape it doesnt save what you have done.
Electronics Forum | Fri Sep 25 10:28:08 EDT 2009 | leemeyer
Are you running Q-soft software or is this an older machine running central controller ? Do you have seperate profiles set up for 0603 caps and 0603 resistors or just one profile for all 0603 parts. It sounds to me that you might be scanning to low a
Electronics Forum | Thu Jan 14 06:27:50 EST 2010 | bobpan
Hello, Havent done them on this machine for 15 years but the manual i have says to go to the teach menu....answer yes/no to local fids taught by autoprogram. If no....enter feeder number and place number then teach. Bob
Electronics Forum | Thu Jan 14 10:07:01 EST 2010 | leemeyer
Placement numbers are 4 digits long, the first digit is the head# followed by a 3 digit placement number. For example if you adding a local fiducial for placement #3 you need to enter 1003.
Electronics Forum | Fri Jun 25 22:30:47 EDT 2010 | smthexi
i think you need to use a PCB central support. do you know that part ? it specializes in preventing PCB board from bowing during wave soldering.
