Electronics Forum | Tue Jan 23 15:20:59 EST 2007 | stepheniii
On the Ekra those are called top clamps AKA finger slicers. With the Ekra side clamping means there is nothing on the top of the board. Does your printer have true side only clamping? Or do you need the top finger slicers for the grid-lok to work r
Electronics Forum | Wed Mar 26 09:26:12 EDT 2008 | lloyd
I know you said you checked your clamps but another look will do no harm. we had a very similar issue a while back, and it turned out that the plastic shim under the chase clamp magnet was damaged. This caused the chase clamps not to release properly
Electronics Forum | Tue Apr 19 21:23:37 EDT 2022 | kumarb
Hi. On our YV88X (Emerald-X), we use the edge clamp + Push-IN clamp to secure the PCB. The push-in metal part pops up fine but unable to move this piece to the LEFT or RIGHT using the dial inside the machine. The latch inside the machine is rotated '
Electronics Forum | Fri Jul 12 12:52:14 EDT 2002 | pjc
I believe its called a BGA Clamp.
Electronics Forum | Wed Nov 29 11:49:57 EST 2006 | slthomas
That, and is it pinned or clamped, and if the latter, are the edges true?
Electronics Forum | Mon May 19 11:10:59 EDT 2008 | cyber_wolf
AJ. The mechanical clamping units on the xyz table are notorious for slipping on these machines.
Electronics Forum | Tue Jul 22 13:45:19 EDT 2008 | gemengr
any one know the part# for the cable that clamp the stencil??
Electronics Forum | Wed Apr 25 14:55:01 EDT 2012 | swag
DMI International
Electronics Forum | Fri Dec 07 07:29:50 EST 2018 | davef
"Send a RFQ" here: https://smtnet.com/mart/
Electronics Forum | Fri Feb 02 15:22:32 EST 2024 | carl_p
Machine a clamp into or from the FR4. to Tension the boards into place