Electronics Forum | Wed Nov 29 11:49:57 EST 2006 | slthomas
That, and is it pinned or clamped, and if the latter, are the edges true?
Electronics Forum | Mon May 19 11:10:59 EDT 2008 | cyber_wolf
AJ. The mechanical clamping units on the xyz table are notorious for slipping on these machines.
Electronics Forum | Tue Jul 22 13:45:19 EDT 2008 | gemengr
any one know the part# for the cable that clamp the stencil??
Electronics Forum | Wed Apr 25 14:55:01 EDT 2012 | swag
DMI International
Electronics Forum | Mon Jun 04 09:20:38 EDT 2018 | dekhead
>> mis-alignment?
Electronics Forum | Fri Dec 07 07:29:50 EST 2018 | davef
"Send a RFQ" here: https://smtnet.com/mart/
Electronics Forum | Fri Feb 02 15:22:32 EST 2024 | carl_p
Machine a clamp into or from the FR4. to Tension the boards into place
Electronics Forum | Wed Mar 13 14:17:03 EST 2002 | dougt
Are these sensors the reflective type? Maybe when the board is unclamped and it goes over the sensor it is seen, and then when it is clamped (raised) it is now out of the range the sensor was set for. That should be easy to adjust. A problem I've
Electronics Forum | Tue May 02 18:08:32 EDT 2006 | Nirmal
are u using 3d / 2d camera 1) machine setup support pin must be strong. 2) machine part libary must be perfect and good condition. 3) using the right nozzle. 4) check the board clamp must be clamp fully. 5) and we can also try doit head and camera
Electronics Forum | Tue Aug 29 14:21:24 EDT 2006 | billyd
Dude: I have used the Grid-lok system before, in DEK 265 and DEK Infinity printers (clamps) and they worked quite well. But, we did have the side clamps. I'm not sure how that translates to an MPM. They were the best we could find as far as the
