Electronics Forum | Thu Sep 26 20:43:51 EDT 2002 | davef
"OK. If the connection doesn't look like I expect it to look, how do I know that the metallurgy is correct?" Comments are: * There are no pictures that will get you though this. * You should expect that gold that is dissolved in Pb/Sn solder to make
Electronics Forum | Mon Jun 19 09:47:23 EDT 2017 | georgetruitt
You have a lot to think about! What does the flux manufacturer recommend as far as specifics like water temp or pressure? Do they recommend high temp di-water a detergent or saponifier? Do you currently have a cleaning machine, batch cleaner or inl
Electronics Forum | Tue Feb 15 00:27:39 EST 2011 | jeffr
First clean and de-bur the hole in the nozzle, then try it again. If the Head does not pick up at the feeder, then moves to the dump position...it means that the Vacuum Sensor Board has detected that the nozzle vacuum is above the LOW threshold setti
Electronics Forum | Tue Sep 22 16:39:10 EDT 2009 | rmitchell
Hi, We are getting a E-Hydra-1 Frame grabbing failed on caps and resistors and also a Light Curtain trigger X wagon. I spoke with mydata and they indicated the light curtain might be getting set off and causing the frame grabbing failure. I cleane
Electronics Forum | Fri Oct 28 04:56:12 EDT 2016 | lilybell
I read a few posts here about resistor in led applications. The thing is, the resistor has clarified as this shows:was always use with a power source delivering a higher forward voltage than the led could tolerate(ex: a 9volt battery hook up to a 3w
Electronics Forum | Thu Feb 26 12:06:59 EST 2004 | jimih280
I need a tape and reel vendor for 5mm through hole LEDs. Any recommendations and what do they charge?
Electronics Forum | Fri Mar 19 12:17:15 EDT 2010 | stepheniii
Be carefull if you go to no clean. Or be prepared from complaints from the test department regarding their ICT pins getting dirty.
Electronics Forum | Wed Mar 04 14:35:16 EST 2009 | clampron
Good Afternoon Everyone, I have a customer who is inquiring as to the use of a no clean solder paste on their RoHS assembly. We are currently building this with OA, cleaning and then underfilling the QFN, BGA comonents after a sucessful ICT. Does any
Electronics Forum | Mon Feb 19 11:25:07 EST 2001 | markt
I am currently cleaning solder paste and adhesive stencils and misprinted substrates manually by using IPA, chem wipes, Q-tips, etc. Can you recommend a machine and chemistry that will clean all these applications?
Electronics Forum | Tue Sep 29 11:49:02 EDT 2015 | spoiltforchoice
Typically - hand soldering as you are currently doing. Should your volume justify it you can invest in a selective soldering solution, these might take the form of a robotic arm that essentially replicates manual soldering or a solder jet similar to