Electronics Forum | Tue Jun 13 15:03:54 EDT 2017 | mmjm_1099
For many moons, I have used IPA for our cleaning tanks within out DEK systems. Now we have a new engineering team and he would like to try a stencil cleaning solution (DEK PRO XF). Can everyone tell me there pros and cons of using each of these over
Electronics Forum | Mon Jun 19 09:47:23 EDT 2017 | georgetruitt
You have a lot to think about! What does the flux manufacturer recommend as far as specifics like water temp or pressure? Do they recommend high temp di-water a detergent or saponifier? Do you currently have a cleaning machine, batch cleaner or inl
Electronics Forum | Thu May 27 22:29:14 EDT 1999 | Mike Flori
Does anyone have a suggestion for a UV resistant black potting material? The material recommended by a local vendor turned gray in a couple of months in the sun here in Florida. We are using L.E.D.'s in a small housing (about 1.2" cube) and need to s
Electronics Forum | Wed Sep 02 06:15:39 EDT 2009 | bobpan
First thing to do is make sure the y-axis encoder scale is clean. Usually on these machines you can view the status of the read head or there is a led on the cable from the read head that will let you know if it is working correctly. Green means its
Electronics Forum | Mon Aug 22 08:54:15 EDT 2016 | bobpan
More than likely the encoder scale or read head has an issue. Many times.. oil/dirt/water get on the scale and cause a bad spot or bad area. Try to clean the scale with a lint free cloth and alcohol. You should also be able to see the read head and m
Electronics Forum | Thu Aug 26 13:09:08 EDT 1999 | Doug
I am building a board with T1/34 LED's in a 10X10 array there are 12 arrays in a panel. The LED's are body to body in the array, .1 spaced. The LEDS have been autoinserted on a Universal RAD III, so they are cut and clinched. The trouble I am having
Electronics Forum | Mon Aug 30 16:14:58 EDT 1999 | Dave F
| I am building a board with T1/34 LED's in a 10X10 array there are 12 arrays in a panel. The LED's are body to body in the array, .1 spaced. The LEDS have been autoinserted on a Universal RAD III, so they are cut and clinched. The trouble I am havin
Electronics Forum | Tue Feb 15 00:27:39 EST 2011 | jeffr
First clean and de-bur the hole in the nozzle, then try it again. If the Head does not pick up at the feeder, then moves to the dump position...it means that the Vacuum Sensor Board has detected that the nozzle vacuum is above the LOW threshold setti
Electronics Forum | Wed Dec 04 08:00:57 EST 2019 | kylehunter
Thank you both. We are using EP256 Solder Paste Sn63Pb37 no clean from Kester. I attached our profile as well as Kester's target profile. We used a populated demo board for the profile. We tested along the width, and was less than a 2c difference.
Electronics Forum | Fri Dec 10 14:49:57 EST 1999 | John Thorup
Hi Mike consider buying your LEDs from a value added distributor or sending the to a service house for trimming. It's no trick to cut so that one lead is longer than the other although you may have to pay a tooling charge. These people are equipped
.gif)
