Electronics Forum | Tue Mar 06 07:04:44 EST 2018 | alpha1
If you have the @? you have communication to the controller. If you send me the exec I can tell you if it's the right one. After that take the old battery out and put the one in that reads 3.1. It's probably ok just needs a charge. Once you get a goo
Electronics Forum | Wed Dec 12 14:26:09 EST 2012 | felo
Hi, I'm wondering if there are any commend to read the feeders coordinates. I know only two: - @WRITE BRD - to send pick and place file - @READ B - to read pick and place file Thanks in advance Lukasz
Electronics Forum | Thu Dec 27 15:11:30 EST 2012 | felo
Not everyone can speak English fluently. I'm glad that You can. Please respond constructively. Are there any other commands in philips 60v?
Electronics Forum | Mon Mar 05 11:12:13 EST 2018 | assuredtech
Without a known good Executive and a known good battery and a known good Comm cable, card swapping / exchange is probably not going to be helpful yet. I might have an Executive you can try, I'll try sending you an e-mail.
Electronics Forum | Sat Mar 17 13:53:47 EDT 2018 | introlab
Hi . When you reload the exe file to machine you must configurate the system by type sys in terminal and define some parametrs
Electronics Forum | Sat Mar 17 14:34:12 EDT 2018 | introlab
Hi Don is it possible that you send me this windows com program ,I would like to upgrade my old dos ppu. Thanks.
Electronics Forum | Tue Mar 27 13:24:31 EDT 2018 | proceng1
That WINDOWS software that Don has makes it so much easier to work on, and run the machine.
Electronics Forum | Wed Mar 28 01:59:13 EDT 2018 | introlab
Hi Don sorry for delay . My contact is email: alen.ebner@siol.net Best Regards. Alen
Electronics Forum | Tue Mar 06 08:03:42 EST 2018 | wolverine55
Thanks Don, I will pass this info on to the Maintenance department at the plant where this machine is located. I did see an exec stored in the machine's host computer while it was there, it was under a UIC filename of BC237A. They have new 3.6 volt
Electronics Forum | Mon Mar 05 07:53:28 EST 2018 | wolverine55
Hello All We have a Universal Model 6287A that is estimated to be about 25 years old. It has run fine for most of it's life but recently has stopped communicating with it's host computer, whenever any commands were attempted to be sent to the machine