Electronics Forum | Thu Jul 21 08:24:28 EDT 2005 | dougs
are you going to clean the boards prior to coating?
Electronics Forum | Mon Aug 01 18:50:46 EDT 2005 | crishan
Hi Cecil, We using conformal coating in our manufacturing area, we did use to use Humiseal, others have been Bectron and Peters. We recentalt switched all lacquering to Peters, since it is lead free and it is a lot friendly than Humiseal. To answer
Electronics Forum | Wed Jul 20 10:07:05 EDT 2005 | cecil
Does anyone have any input on the need to bake out an assembly prior to the conformal coat process? I understand baking out components/pwb's prior to processing through the reflow or wave solder process if the material shows excess moisture absorbtio
Electronics Forum | Wed Jul 20 15:18:35 EDT 2005 | FW
Hi! We have both Dip & Spray conformal coating processes & have never done any kind of baking before the process! I am assuming the reason for baking would be the same - ie, remove any moisture on the brds since moisture will create failure of the co
Electronics Forum | Wed Jul 20 15:33:38 EDT 2005 | cecil
QC dept. refrain from giving direction!! Geez have I died and gone to heaven?
Electronics Forum | Thu May 20 11:36:57 EDT 2010 | davef
Ansell ANS 11-100 HYFLEX (ESD) static dissipative coated Size||Ansell p/n||Techni-Tool p/n 7||ANS111007||328PR107 8||ANS111008||328PR108 9||ANS111009||328PR109 10||ANS1110010||328PR110
Electronics Forum | Thu Jul 21 14:16:56 EDT 2005 | stepheniii
Tell them every action taken with the boards carries risk of damage. Process steps that don't do anything should be avoided because they carry the risk of causing defects. Even inspection causes the occasional defect, and board handling in general s
Electronics Forum | Thu Jul 21 14:42:47 EDT 2005 | jdengler
Stephen, If you have ever gotten QC to buy into this logic you have a much better QC department than most. Jerry
Electronics Forum | Tue May 25 07:19:13 EDT 2010 | jry74
I tried these and the operators didn't like them. The palm dip didn't slide well on tape and the finger tips were a bit bulky.
Electronics Forum | Wed May 19 19:41:12 EDT 2010 | jry74
Our employees use a knit style ESD glove when masking boards to prevent oils. They snag alot and bend leads and cause other problems. I have tried dipped palm but they are bulky and dont offer "feel". I tried a silky type but they had a huge seam
