Electronics Forum | Wed Mar 10 11:19:59 EST 2004 | mrmaint
Paul, I have seen harness issues in the past that have given some unusual results. The problem we found was that depending on the rotation and position of the cut/clinch unit the opens/shorts were not consistent. The first place i would look is at th
Electronics Forum | Tue Jun 27 20:24:56 EDT 2023 | auriga2001
If you're lucky, it's just a bad boot sector. You can take the drive out, hook it up to another computer and copy it before trying to fix anything. Then try to reinstall programs if you have them. If you're unlucky the hard drive died. You might be a
Electronics Forum | Tue Feb 17 11:14:03 EST 2004 | remullis
Hi, I have worked with the CS400E's for 10+ years and normally when your having problems optically programming. The light bulbs are either getting dark or the filament is not positioned correctly. To set this, you will need a meter to check across
Electronics Forum | Wed Mar 10 08:08:49 EST 2004 | paul_bmc
I am having issues with a CS-400E that I thought I might ask if anyone has any suggestions. The machine may run fine for a while then out of the blue the cutters stop responding or start responding erratically, you have to hit the esc key after ever
Electronics Forum | Wed Jan 05 10:50:29 EST 2000 | Phil B
Hi Greg, I have the same problem over here in Belgium. I have been looking to rent an X-ray but for the moment I only found Glenbrook as a possible source. So I would be very interested if you find any alternative. Furthermore I am also interested i
Electronics Forum | Fri Sep 22 11:52:47 EDT 2006 | basem
Then Fuji it is. I'm happy with the features the Juki's R seriers are giving out. It is like, everything I could think of a placement machine if I would design one for myself...the 2060R is something I would buy happily...especially after you telling
Electronics Forum | Wed Feb 11 13:54:27 EST 2004 | fatally_phoenix
I don't personally know how to program that machine or diagnose any problems that it may have, but you may want to call Bob Tomelicity over at Magellan. He is a former tech of theirs and we refer all of our clients, that have a Contact Systems machi
Electronics Forum | Tue Jun 20 16:09:29 EDT 2023 | nickadams
We have a Contact System CS400E with a Rotary Bin model CS201 with 90 bins and we're sort of new to programming it and are wondering how we can program the bins so that we can assign a part number to a bin. What happens now is it always goes to the f
Electronics Forum | Thu Jun 29 00:33:15 EDT 2023 | auriga2001
My background is in I.T. Here's what's likely the cause. It's old and worn out. Not much else to offer technical wise. Hard drives are mostly permanently sealed to keep dust out and have moving parts. Eventually they wear out. The way to prevent fail
Electronics Forum | Mon Feb 02 16:30:46 EST 2004 | paul_bmc
I have one machine that I am having trouble getting the machine to recognize an offset. I keep getting the error, "When correcting Offset 1: Invalid offset, press 'esc". Does anyone know what I am doing wrong. On another machine I have I keep havi
Electronic manufacturing services - electronic design, development and manufacturing. Circuit board design, prototyping, FPGA services, signal integrity and simulation, pcb assembly. Factories in California USA and Malaysia.
Manufacturer / Consultant / Service Provider
3240 Scott Blvd
Santa Clara, CA USA
Phone: +1 408 980 0400