Electronics Forum | Fri Mar 22 03:19:43 EDT 2019 | bukas
well, in video shown it looks like #1 motor drives head #1 upwards but does not detect home sensor being triggered. and then you get timeout error, head not being able to reach the position ( machine not registering it has reached position). since yo
Electronics Forum | Fri May 01 00:27:12 EDT 2009 | rodrigo
Hi all, We had a servo amp replaced (SA-6) and the machine worked with no problem for the first panel (this panel of 10 only needs a TQFP100 from the MTU). Then I got the "Servo NG" error again. One of the servo paks showed a "7" on the LED. The err
Electronics Forum | Thu Mar 21 12:09:28 EDT 2019 | alexcouto
Hello Bukas, thanks again. Since at an early stage I switched heads # 1 and # 6 and they are not compatible, then I went through the manual and figured out why. in order to start at the beginning and check that it had not damaged anything, I put the
Electronics Forum | Tue Feb 11 15:31:10 EST 2020 | sumote
We have not used out tray handler in several years, and when I had a need arise the thing now throws a Servo Error "MTU1 ALARM [11081010]. There are 4 servo packs in the cabinet. When I try to initialize/zero out the machine the 2nd and 4th servo pa
Electronics Forum | Thu Dec 14 21:56:25 EST 2017 | jmelson
I checked the brushes, there is lots of length left on them, and the springs and pigtails are in good shape, too. I have been checking various cables, and reseating connectors, but making a resistance measurement from the brush holders back to the s
Electronics Forum | Thu Aug 18 02:39:21 EDT 2016 | epsltd
We have a Mirae 1030 and when the machine warms up the y-axis fails and we are unable to reset servos unless we leave machine powered down few hours. Now since we have changed servos after machine homes we jog the y-axis and it vibrates and very nois
Electronics Forum | Wed Feb 23 15:07:58 EST 2005 | bobpan
Hello C.B. I am a former trainer/fse for that machine and still have a q1000 bible for fixing problems. I think the machine may need servo tuned to which there is a procedure that i would have to find. First thing to do though, is to drop the machine
Electronics Forum | Thu Feb 13 09:52:03 EST 2014 | rgduval
Start by getting into the maintenance menu, and manually installing the Servo program for all MOTs. If they install fine, you can check the Z-motor while you're in the maintenance menus. Make sure that the z-locks are unlocked before checking the
Electronics Forum | Mon Nov 29 13:39:48 EST 2021 | oxygensmd
Is it a running machine or a first startup? For me, it seems to be some configuration error. For example problem with some card (iCos, MC, servo controller). At first check table and WPC connectors are fitted properly than check the status LEDs on y
Electronics Forum | Thu Apr 28 03:58:52 EDT 2022 | erici
We are having problems with our Siemens Siplace S27 machine. The machine is giving the error - Y-axis Faulty initialization of Motor. We replaced the Y motor card and swapped also the servo control cards on the two gantries. Still will not initiali
.gif)
