Electronics Forum | Tue Sep 19 15:15:42 EDT 2006 | bigdaddysoy9
Have you tried changing the motor?
Electronics Forum | Fri Jul 26 07:21:07 EDT 2013 | falvarez
thanks!! confirmed!
Electronics Forum | Thu Jun 13 20:03:05 EDT 2019 | dekhead
Does it cycle in/out in diagnostics? Have you checked pneumatics to to the RS cylinder?
Electronics Forum | Wed Jun 19 18:44:56 EDT 2019 | dekhead
Is the signal making it to the SOL? Is it toggling when signal is present? RS Cylinder is to the rear of the RS rails.
Electronics Forum | Sat Feb 11 02:50:07 EST 2023 | dekhead
Please contact me directly; DEKHEAD@ATT.NET
Electronics Forum | Tue Feb 14 05:01:29 EST 2023 | leeg
Sounds like the brake may have gone?
Electronics Forum | Thu Jun 20 10:23:47 EDT 2019 | key
Would you happen to have a picture of the RS Cylinder and Rs rail. When we send the table in sol 4 is on. When we try to send the table out sol 4 and 5 are on. We are having a hard time finding the RS Cylinder and RS rail
Electronics Forum | Tue Sep 19 10:30:54 EDT 2006 | dekhead
I think you may be remembering wrong. Timer circuit will normally cause table drop when system power is re-applied, not when it is removed.
Electronics Forum | Wed Aug 20 06:33:16 EDT 2008 | benefon
If this is machine is of the same type of construction as our 248 with the pneumatic table sliding mechanism, check the 'table out sensor' in the 'digital inputs' section of the diagnostics menu. rgds AR
Electronics Forum | Fri Feb 10 12:21:20 EST 2023 | youngbuck
Also, tried swapping the Servo card. X7 which is the Rising table servo motor card, swapped with X8,9,10 which are all the same and same result.