Electronics Forum | Tue Jul 13 13:30:16 EDT 1999 | Bill Bannister
We are looking to automate the paste printing portion of our SMT process. We are looking at used equipment from DEK and MPM from 1994 onward.(DEK 260 & 265 MPM AP20 & AP27) Does anyone have some feedback or concerns with any of these machines? Does t
Electronics Forum | Fri Feb 17 14:32:53 EST 2006 | gipos
Hi all, The question for experienced operators: DEK 260 or DEK 265, which one is more suitable for high mix low volume to mate Juki 700 series line ? Is there any specific known issues regarding service, operation, repeatability... ? We have target
Electronics Forum | Mon Oct 11 17:02:06 EDT 2004 | M Deren
We have a DEK 260 with a intermittant table align stepper motor problem. The machine will work fine for awhile and then one of the table align motors starts either moving hapazardly in small increments back and forth or vibrates as if it wants to mov
Electronics Forum | Mon Oct 11 17:06:55 EDT 2004 | M Deren
We have a DEK 260 with a intermittent table align stepper motor problem. The machine will work fine for awhile and then one of the table align motors starts either moving haphazardly in small increments back and forth or vibrates as if it wants to mo
Electronics Forum | Tue Feb 22 17:03:48 EST 2000 | Chris
Dek 249 and Dek 260 models use to have fiducial recognition where table would adjust to the stencil. However, I would still recomend you buy an inline model because the change over will be much faster. Probably 10 times faster.
Electronics Forum | Tue Feb 22 17:03:48 EST 2000 | Chris
Dek 249 and Dek 260 models use to have fiducial recognition where table would adjust to the stencil. However, I would still recomend you buy an inline model because the change over will be much faster. Probably 10 times faster.
Electronics Forum | Wed Oct 13 17:05:02 EDT 2004 | kmakiya
I have seen stepper motors chatter or vibrate when it has lost one of its phases. You've replaced everything but the cable so I think you are right that it should be checked for an intermittent connection.
Electronics Forum | Mon Oct 18 10:55:17 EDT 2004 | DenisM
Check the ground plane for noise with a scope. Steppers are very sensitive to spurs and will step in response to noise. Resistance welders on the same ground loo[ can be a problem as can seam sealers etc. Denis M Manncorp
Electronics Forum | Fri Oct 26 08:29:03 EDT 2007 | pjc
Try this guy, maybe he can hook you up: http://www.dekhead.com/index.html
Electronics Forum | Mon Jan 30 17:42:50 EST 2017 | jrr3434
A few of the LEDs on the cameras of my stencil printer are really dim. I want to replace them and not have to buy a whole new light ring board. Does anyone know what kind of LED they are? Any info would be appreciated. Thanks.