Electronics Forum | Fri Jul 29 15:53:26 EDT 2016 | davef
Much a the accumulated knowledge is here: IPC-2252 - Design Guide for RF/ Microwave Circuit Boards [http://www.ipc.org/TOC/IPC-2252.PDF]
Electronics Forum | Wed Apr 20 12:22:51 EDT 2005 | jdengler
Russ is correct, but you may have variations between board density types also. Some ovens may be able to handle low density boards with no spacing, but need a zone's worth of spacing for high density boards. Other ovens don't need any spacing for a
Electronics Forum | Thu Sep 30 16:10:50 EDT 2010 | jeremie
Inherrently there is this perception that the higher the density of components on an SMT assembly the better the machine performance. Would you stand behind this theory? I thought that I would, but I can't seem to prove it mathematically. By that
Electronics Forum | Wed Aug 13 11:13:03 EDT 2008 | mbnetto
Hello... I need to calculate the solder paste quantity that I'll need for a new product and I need the density of the solder paste Cookson OM338PT. Can anybody help me? Thanks!
Electronics Forum | Wed Jul 11 13:55:26 EDT 2007 | bschreiber
We have received several e-mails and phone calls regarding the Permali recommendation of cleaning Durostone pallets so I thought I would address these questions on the forum for everyone's benefit. Q: Can 440-R SMT Detergent be used for manual clean
Electronics Forum | Tue Aug 28 07:14:32 EDT 2001 | markhoch
Anybody know where I can find a supplier of hydrometers to check flux density?
Electronics Forum | Tue Sep 17 08:26:28 EDT 2002 | davef
Try: "Increasing Density By Placing Vias In Lands"; Blankenhorn, JC; 'Printed Circuit Design'; 11/98
Electronics Forum | Thu Mar 27 19:07:20 EST 2003 | jonfox
Just to be sure, you really should. PCB thickness and component density are the key players.
Electronics Forum | Sun Feb 27 17:39:25 EST 2005 | pmdeuel
Dross is a combniation of oxides and lighter metals. It will float in all but very light density metals.
Electronics Forum | Wed Aug 13 12:48:27 EDT 2008 | mbnetto
If I had the stencil and the PCB I would have done this before. But I don't have both!
.gif)
