Electronics Forum | Wed Oct 24 12:34:49 EDT 2007 | resource
You could have look at LASER QUADRA Pick & Place Machine manufactured by TWS Automation, Italy (www.tws-automation.com). Its a small foot print, 3000CPH, 0402 capable, 20mil capable, BGA capable, machine with motorized feeders . Dispenser is an optio
Electronics Forum | Tue Oct 31 19:28:24 EDT 2023 | ttheis
We built our own coating system by mounting a Universal Robots UR5 to an edge conveyor between a magazine unloader and magazine loader. The robot has a needle dispenser on the head. We chose a needle dispense process to avoid aerosols and complex ven
Electronics Forum | Mon Mar 03 09:57:26 EST 2003 | msivigny
Hello markt, If you're only running at 85%, you've got some things to look into! First, it's good you know that you're operating at 85% with some measurables that help you determine that. Now, the easiest methodical way to improve productivity on SMT
Electronics Forum | Tue Nov 08 04:11:34 EST 2005 | Eric C
I am trying to find out if there is any solvent for underfill material that has hardened/cured. Regular/routine maintenance of our dispenser units requires thorough cleaning oftentimes scraping is done for material that has hardened. Any inputs would
Electronics Forum | Thu Sep 10 17:13:31 EDT 2015 | tombstonesmt
There are factors that manufacturers have taken into consideration when dealing with coating. On/off times, dispense speeds, heights, etc.. Dedicated software with tools to easily map out paths are a godsend. We made our own coating machine with a s
Electronics Forum | Fri Sep 11 12:08:10 EDT 2015 | derrikf
I built one using an old Asymtek Automove. When all was said and done, it cost less than $400, including what was paid for the machine itself. It's a very basic setup, (air over syringe), but for our needs it does everything and more. With air to syr
Electronics Forum | Thu Dec 30 14:40:05 EST 1999 | Sergio Luiz Vito
I am Looking for used dispenser machine manufactured by panasonic (HDP-G1 or HDP-G3). Thanks Eng. Sergio Luiz Vito
Electronics Forum | Tue Nov 14 16:06:27 EST 2000 | zorox
We have an ERSA machine here where we have solder "spikes" occasionally. We have made sure our flux is dispensing properly, we have adjusted z axis speeds, our preheater is heating properly, adjusted XY speeds, etc. Can anyone think of something we m
Electronics Forum | Thu Dec 30 22:01:33 EST 1999 | Dave F
Sergio: You're looking on all the wrong places. Go to: * SMTnet PCBCE Mart * chipshooters.com * ipc.org * Any of the myrid of equipment brokers listed in the archives * Panasonic Good luck Dave F
Electronics Forum | Tue Jun 08 17:31:15 EDT 2010 | whitewing
For protos and very short runs I already use a polyester stencil + pizza oven process which is fine except for the placement time and tedium. I'm partly trying to bridge the gap between that and stuff that needs subbing out due to quantity, and partl
A Manufacturer of High Quality, Precision, Automated Fluid Dispensing and Conformal Coating Systems, SMT Cover Tape Peel Tester and Lead Forming machines for through-hole component preparation.
611 Hollingsworth Street
Grand Junction, CO USA
Phone: (970) 245-0408