Electronics Forum | Mon Feb 24 11:24:36 EST 2014 | cyber_wolf
Nothing is locking up or sticking. It's just getting cruddy.
Electronics Forum | Thu Oct 02 10:55:37 EDT 2003 | caldon
Brad- The Spec can be downloaded free from IPC at http://www.smema.org/smema1.2.pdf (or IPC.org search for SMEMA Standards). As per Conveyor edge clearance should be .187" or 4.7mm. Regards, Cal Communications Test Design, Inc. www.ctdi.com
Electronics Forum | Wed Jun 30 12:14:40 EDT 1999 | John Thorup
| | We are wave soldering some fabs with a lot of unmasked trace area along the edges. The trace area is solid copper covered with tin / lead, no masking, no components along the edges, same on solder side and component side (goofy board design). I
Electronics Forum | Fri Jul 02 09:54:02 EDT 1999 | John Thorup
| | | | We are wave soldering some fabs with a lot of unmasked trace area along the edges. The trace area is solid copper covered with tin / lead, no masking, no components along the edges, same on solder side and component side (goofy board design)
Electronics Forum | Fri Jul 02 10:06:17 EDT 1999 | John Thorup
| | | | We are wave soldering some fabs with a lot of unmasked trace area along the edges. The trace area is solid copper covered with tin / lead, no masking, no components along the edges, same on solder side and component side (goofy board design)
Electronics Forum | Wed Oct 01 23:40:38 EDT 2003 | bradlanger
I was wondering if anybody could tell me what a good clearance would be for board designs to allow for the use of inline equipment? My company currently runs a batch line but I want to make sure we are designing properly for inline if the need arises
Electronics Forum | Sat Feb 15 10:31:53 EST 2014 | marcpeo
Sorry to say that most top out at 350 deg. Best to have it done outside. Is the chain locking up or not moving smoothly? If no signs of sticking then maybe no need to heat at all.
Electronics Forum | Fri Jul 02 05:28:13 EDT 1999 | Vinesh gandhi
| | | We are wave soldering some fabs with a lot of unmasked trace area along the edges. The trace area is solid copper covered with tin / lead, no masking, no components along the edges, same on solder side and component side (goofy board design).
Electronics Forum | Wed Jun 30 17:58:01 EDT 1999 | Boca
| My guess would be trapped flux continuing to be active after soldering. Is the tarnish there immediately after exiting the machine? Do you remove the mask and wash right away? If the solder is reflowing under the mask on the component side it wo
Electronics Forum | Fri Feb 14 14:09:06 EST 2014 | marcpeo
In general the chains don't need to be heated to 400 deg C for cleaning. In other words, most of the fluxes and constituents in the paste don't collect on the chain and gum it up. Bottom line: the heat treatment is not needed for 95% of the users.
Electronic manufacturing services - electronic design, development and manufacturing. Circuit board design, prototyping, FPGA services, signal integrity and simulation, pcb assembly. Factories in California USA and Malaysia.
Manufacturer / Consultant / Service Provider
3240 Scott Blvd
Santa Clara, CA USA
Phone: +1 408 980 0400
