Electronics Forum | Fri Mar 24 08:10:12 EST 2006 | mapell
Hi AR Nice job on the chain/rail cleaning. I would contact Speedline Electrovert tech support, 800.737.8110 to assist in trouble shooting. They can walk you through using a meter to measure input and output current to the SC card and make sure tha
Electronics Forum | Mon Mar 27 09:35:11 EST 2006 | cyber_wolf
The only problem with the Tribol is PB Free profiles. At thses temps, the Tribol smokes and stinks bad. It also has a tendancy to carbonize. I find myself having to use easy off to clean the chains.
Electronics Forum | Mon Mar 27 11:24:59 EST 2006 | mac
Had similar issue with Omniflow. Was actually jostling tall electrolytic caps off of pads. Found that idler sprockets/pulleys needed lubed.
Electronics Forum | Tue Mar 28 04:49:39 EST 2006 | AR
All's well that end's well: I replaced the Dart speed controller card and the problem disappeared completely. But no harm in giving the chains and the rails a thorough scrub although they weren't the culprit in this case. Many thanks to everyone for
Electronics Forum | Thu Aug 11 16:20:54 EDT 2005 | pjc
I have seen good results on OmniFlo 5 for Pb Free solderpastes PROVIDED the boards are low to medium thermal mass and have no high conveyor speed (high production) requirements. Max peak temp you can set on O5 is 280C, enough to get 230C on-board tem
Electronics Forum | Tue Mar 21 07:31:54 EST 2006 | cyber_wolf
We had the exact same problem on our OMNI 10. We found that two of the rails the pin chain rides in were warped. Somehow at one point our PC lost communication with the oven and the heaters went wide open for several minutes...this is what caused th
Electronics Forum | Mon Mar 27 02:08:25 EST 2006 | AR
Up till now we have been using the Tribol 930 but it is practically impossible to obtain here in Europe at least. Speedline is extremely reluctant to sell it for some reason that I cannot figure out. Currently we are testing Anderol XL 220 but it is
Electronics Forum | Mon Mar 27 11:03:06 EST 2006 | mapell
Tribol 1430 is the latest generation oil, 930 can't take lead free temps. Please see the following link.... http://www.castrol.com/castrol/productdetailmin.do?categoryId=82958955&contentId=6004371 If your getting alot smoke and residue, reduce the
Electronics Forum | Wed Sep 25 16:01:17 EDT 2013 | action_101
We have the thermal connections on our omniflow, but we prefer to use the mole. I actually prefer the kic profiler over the mole profiler, but you work with what you have sometimes. The benefit of using an external system is you don't have the long t
Electronics Forum | Thu Sep 26 12:53:31 EDT 2013 | markhoch
I'm not sure where you're located, but you should try contacting your Regional Sales Rep for ECD or KIC Thermal. They often times have demo units that they are required to "demo" several times per year. They may be willing to come in and profile your