Electronics Forum | Sat Oct 03 15:51:06 EDT 2015 | amrsalama
I have the same problem and while using logicomm it gives an error message (FC107F24) !!! how can I read this error to address the problem ???
Electronics Forum | Sat Jul 03 14:16:06 EDT 2021 | tomdegas
Thanks Rob. I didn't know I can run DOS on a Linux Operating system. Tom
Electronics Forum | Sat Jul 03 14:44:12 EDT 2021 | rgduval
Meh...it's a Linux command line....but commonly referred to as a dos prompt. When I started on MyDatas, no one really knew what Linux was....
Electronics Forum | Wed Jun 30 20:35:04 EDT 2021 | rgduval
I have no idea what the messages mean specifically...but, it sounds like linux level errors, rather than TPSYS errors. Start by getting to a dos prompt, and navigate to those directories cited and make sure things look ok (files are there, directo
Electronics Forum | Wed Feb 23 13:50:55 EST 2005 | c.b
I am currently using a quad 1000, and up to now it has been a good reliable machine upto yesterday. I now have an error message that reads "driver error, emergency stop" the machine then freezea and will not run. Could some one please tell me if t
Electronics Forum | Sun Dec 02 00:17:35 EST 2007 | jmelson
I finally figured it out - in my manual it shows as a "63:Overflow" and says it has run out of memory for management information. I finally realized they were talking about the MIS statistical data of feeders, heads and mounting programs. I cleared
Electronics Forum | Fri May 24 11:34:08 EDT 2019 | jstebbs89
Running a Mydata 15E and in the middle of a board the machine will freeze. Restart the machine and try to initiate the hardware, get an error message of F-MOT-MSETDYN X/163: Illegal value of DSP command arguement I've check all the connections on t
Electronics Forum | Mon Jun 21 13:16:18 EDT 2021 | tomdegas
I just received the following messages while running our MY15: I-OSM-0: my15n150 kernel: lp: no devices found. I also received this one: I-OSM-0: my15n150 insmod: /lib/modules/2.2.20/misc/lp.o: init_module: Device or resource busy. And this one: I-
Electronics Forum | Thu Apr 16 09:31:28 EDT 2009 | padawanlinuxero
Hi all! I have a problem, I have a wave solder a Econopak plus by Electrovert, and someone move something when I was not here, now when I try to load a recipe a very specific recipe is givening me a error message : MyrecipeName Isam error 30000: Da
Electronics Forum | Sun Dec 10 22:38:04 EST 2017 | jmelson
I have an old CSM84 with the brush motors, model PA130620. I had a few intermittent feedback errors, now they have gone solid. But, I found slowing the machine to 85% lets it run without the error. So, I'm thinking there may be drag on the axis. T