Electronics Forum | Sat Oct 21 11:21:56 EDT 2023 | ushdogg
This will be a problem as the calibration settings are stored per machine in the Application Support folder. You will also need to know what the last firmware you were running as that decided what software is compatible. PM me I will see if I can ass
Electronics Forum | Tue Sep 06 10:20:33 EDT 2005 | slthomas
I love these stories. At my previous employer we experienced intermittent failures on an audio microprocessor assembly being used on a *new* product. This board had numerous microprocessors and complex firmware aboard. They discovered one PLCC on
Electronics Forum | Mon Nov 07 15:05:16 EST 2011 | tpappano
Hi Jeff, This machine (my unit #2) has a couple programs that execute just fine, but when I added additional mounts to one of them I got the "120"error. When I added another new program, the "118" error showed up, and of course, everything in all t
Electronics Forum | Mon Mar 15 18:36:59 EST 1999 | Dean
| Here is my question. We have several fuji CP's in our shop, every once in a while the first couple of parts placed are off the pads. When we move the parts further down in the sequence they are fine. What is going on? Has anyone had this problem an
Electronics Forum | Tue Mar 05 14:35:15 EST 2002 | slthomas
I don't know much about it, but I know that we at one time had the capability. We don't use it now, however. We have 3 MSHII's, and apparently there's a card that needs a dip switch turned on (the MMC card, maybe?), and a new firmware rev. if they
Electronics Forum | Wed May 05 11:15:52 EDT 2004 | longpham246
Hello! Fuji FCP6-4000 cannot place 0201, unless you have the FCP642 but need to be upgrade with new camera and firmware. The FCP643 is ready for 0201, however, you still need to verify your pick up calibration. Fuji used to sell the upgrade kit for
Electronics Forum | Mon Jan 30 01:46:16 EST 2006 | ____
1) The Binary vision system does not like many variables. 2) I believe that to be a firmware bug. Find out what version you are running and contact either Fuji America Corporation or Fuji Japan directly. You are better off trying FAC.
Electronics Forum | Tue Mar 17 16:09:25 EDT 2009 | gregf912
For the IP3 to reliably place BGAs the machine needs the 4800 vision card and type 12 camera. From the problems i see here you must have the 4400 card and a type 8 or 9 camera. It would also seem that a calibration is in order. I have calibrated and
Electronics Forum | Mon May 16 15:50:52 EDT 2011 | jimlas53
Yes, it looks like it would involve quite a bit... I guess it partly depends on finding the hardware/firmware, possibly from a donor machine. But it might not be worth the cost. At the moment I'm running all product on the first machine with Quada
Electronics Forum | Fri Sep 06 12:34:00 EDT 2013 | bobpan
Your firmware is so old that the problem is not in the mod codes anyways. You have a problem with the cyberoptics head. If its not working at all, i would remove the lens assy on the front side where the cable plugs in and blow out the unit. Maybe if
Electronic manufacturing services - electronic design, development and manufacturing. Circuit board design, prototyping, FPGA services, signal integrity and simulation, pcb assembly. Factories in California USA and Malaysia.
Manufacturer / Consultant / Service Provider
3240 Scott Blvd
Santa Clara, CA USA
Phone: +1 408 980 0400