Electronics Forum | Tue Sep 21 11:34:10 EDT 2004 | davef
Several things to check are: * Ask Multicore if their flux res and your conformal coat are compatible. Conformal coats and NC flux res are notorious for having compatibily issues. * Conformal coat a bare board to determine if there is there is enoug
Electronics Forum | Fri Jul 01 11:00:24 EDT 2016 | sachinverma
its spray fluxer we deassemble the nozzle clean and reassamble again. flux tank also clean with IPA. ya same problem in all product plz find the attachments about flux
Electronics Forum | Mon Oct 23 14:05:08 EDT 2000 | Aokilab
Hi Soza: As Dave F mentioned, there are lot of factors involving the formation of residue, after cleaning. Factors, (such as: solvent's cleaning power, presence of metal oxides, type of soldering flux, etc...). One thing pretty sure, IPC is usually
Electronics Forum | Tue Sep 21 10:53:53 EDT 2004 | davef
We know nothing about Envivar UV 1244 and you weren't real clear about the details of the problem or the materials [eg, ws flux, solder mask, etc], but we'd speculate your adhesion problem goes back to the cleanliness of your board. First by 'alcoho
Electronics Forum | Fri Aug 17 09:32:36 EDT 2012 | jeremymek
I would advise against using IPA for stencil cleaning It may initially seem to produce good results but the way it works you end up with more problems. IPA is good at removing liquid fluxes but it dries out and cements solid fluxes to the stencils
Electronics Forum | Thu Jun 20 16:24:59 EDT 2002 | blnorman
At the OSHA training institute, our instructor stuck an electric drill in a bucket of water to demonstrate what proper grounding will do. Personally I wasn't going to try it. All our fluxes are no-clean, and are IPA based. Granted we used aqueous
Electronics Forum | Mon Dec 21 11:28:47 EST 2009 | lynn_norman
We used Loctite 3609 and never had problems. If memory serves me isn't 3606 a screen print adhesive? First thing I would check is the cure profile of the adhesive. If it doesn't develop full adhesion, could be problems. Nuther question is are you
Electronics Forum | Wed Feb 22 03:29:09 EST 2017 | niki
Which is the best way to clean the PCB after > soldering? Is it good enough with IPA > (isopropyl) or with the Flux Remover > spray? However, we use a lead free solder wire > (3,5% flux inside the core) and after the > soldering its a visible we
Electronics Forum | Mon Jan 27 12:02:00 EST 2003 | Mike Konrad
Dave is correct. No-clean flux + water = white residue (unless the proper chemical is mixed with the water). Additionally, no-clean flux + IPA = white residue. Many saponifiers work well as do other cleaning agents. White residue may also be a re
Electronics Forum | Tue Mar 25 08:29:33 EDT 2014 | sara_pcb
Please refer the attached jpegs, The problem is noticed after reflow soldering followed by conventional through hole soldering. Flux used one is MIL Std. Brush cleaning in IPA is followed after each soldering step. regards, R.Saravanan
