Electronics Forum | Fri Jun 16 19:40:51 EDT 2000 | Ramon I Garcia C
Hi JT I speak little English by i try... I think that you by try with the internet pages about the flux manufacturer, or flux provider.. some time I tried with the search, I type the flux number and appear some sites w/information...like k
Electronics Forum | Thu Aug 24 13:09:30 EDT 2000 | Dr. Ning-Cheng Lee
Yes, a flux with a fast wetting rate will be more prone to have spattering. Fluxes with high boiling point solvents are also more prone to have spattering, if the same flux is fast in wetting rate.
Electronics Forum | Mon Feb 07 13:22:23 EST 2000 | Dave F
Brian: SMTnet has a "Terms & Definitions" section in the "Library." OA Flux. Flux, Organic Acid. A water soluble flux. Good luck Dave F
Electronics Forum | Fri Oct 08 22:14:38 EDT 1999 | Michael
Right now,we have some problem on SMT. Cause of the flux residue in the connector. Do somebody have the same symptom? By the way, can i find something to make the flux observe easy or take a photo with the flux.
Electronics Forum | Thu Apr 09 12:13:22 EDT 1998 | raymond
What is the pro & con of using flux dispensing vs flux dipping method for flip chip assembly ?
Electronics Forum | Thu Apr 02 13:18:18 EST 1998 | Sylvia Ireland
Does anyone know what the military uses for water soluable flux in their wave solder process: - wave flux - rework flux - cored solder and approval steps to go through to qualify it. Any information is appreciated. Thank you.
Electronics Forum | Tue Sep 25 09:57:40 EDT 2001 | nwyatt
In regards to your last question, - problem is failures and most think it is due to too much flux - we apply flux with a brush - amount applied depends on the operator applying it - the flux is very thick and will hold the part in place before reflo
Electronics Forum | Tue Aug 13 16:47:22 EDT 2002 | mick
The residues are from the flux, not adhesive. Do you have flux management system in oven? You also need to check the flux type = can you use low solids. The effect is the same as steam in bathroom - it is cooling affects in exhaust and flux reforming
Electronics Forum | Thu Aug 22 15:31:52 EDT 2002 | Claude_Couture
In an oven with flux reclamation system, once the circulation is prevented by accumulation of flux in the heat exchanger, the flux will condense where it can, and some of it will coat your PCBs with a uniform layer of flux on the parts/ joints/ goldf
Electronics Forum | Tue Jul 08 07:01:40 EDT 2003 | davef
Try: * ANSI/J-STD-004 - Requirements for Soldering Fluxes * ANSI/J-STD-005 - Requirements for Soldering Pastes * ANSI/J-STD-006 - Requirements for Electronic Grade Solder Alloys and Fluxed and Non-Fluxed Solid Solders for Electronic Soldering App