Electronics Forum | Thu Apr 03 12:36:30 EDT 2014 | jimmyboz
Hold the F1 key during power up, it will boot into the I/O screen. Check the 3 photo zones. Check the door switch. In the main screen you can cancel D1 or D2, then you can swap light sensors. Check carefully the wiring, there is a SYNC wire betwee
Electronics Forum | Fri Mar 23 02:22:13 EDT 2007 | bvdb
Latest information: The IP-1 packed up completely this week showing an assortment of weird error messages. The CPU was still running but the +24VDC power supply LED was off and nothing would work (emergency stop mode always enabled). Pulling the +
Electronics Forum | Fri Feb 25 05:12:12 EST 2000 | Dean
...problem? Are you not sure its not a "feature". LOL I have had the same problem...spent many hours tracing down the sequence of events which leeds up to this situation. No real solution...however, I use the key command zero set feature rather t
Electronics Forum | Fri Feb 25 05:12:12 EST 2000 | Dean
...problem? Are you not sure its not a "feature". LOL I have had the same problem...spent many hours tracing down the sequence of events which leeds up to this situation. No real solution...however, I use the key command zero set feature rather t
Electronics Forum | Tue Feb 25 14:39:20 EST 2014 | nicodj77
Stellar Technical Product, we been ordering from them for almost 6 years. My needs where to be used with connectors or power modules on a tray without pick up area (dots) for pick up Fuji nozzle of 5mm. There is no P/N because is a special order, b
Electronics Forum | Wed Aug 11 23:55:19 EDT 1999 | Dean
| | I appreciate you're input on this, John, Scott. It's a neat thing Mydata did with the power out, status saved feature. That comes in handy a lot down here. | The problem is with our machine, however, "I think", is that we have one of our phases
Electronics Forum | Wed Mar 11 12:23:08 EDT 2009 | rodrigo
I changed the satus B bit to disable the MTU (still on though). It doesn't wait for the MTU anymore but I get a Emergency and Door NG errors. The relay tripped. Is there a way to completely disable the MTU (leave it off) and power up the IP? This sho
Electronics Forum | Sat Mar 02 22:33:55 EST 2013 | mdang
Hi Sr Tech, I replaced the AMP and I can home the machine now. The only problem is the AMP display 5 instead of 0 when the power up the machine. I have couple of questions 1) How do you calibrate it to make the AMP display 0 like others? 2) How do y
Electronics Forum | Sat Feb 19 17:10:06 EST 2022 | assuredtech
First off, Fuji machines aren't that simple i.e. changing the CPU could actually make matters worse. There are jumpers, DIP Switches and related data to consider before doing something like swapping cards. Swapping is a shotgun approach but sometimes
Electronics Forum | Tue Aug 09 11:14:28 EDT 2016 | cyber_wolf
•Rated Speed of 40,000 CPH •140 - 8mm Device Locations •14" x 18" Max PCB Size PCB dimensions Max: 457mm x 356mm Min: 80mm x 60mm Board Thickness: 0.3 to 4.0mm Component capacity Up to 140 types (8mm tape) Placing rate 0.09 sec./component - 40,