Electronics Forum | Fri May 09 11:09:47 EDT 2003 | k_h
Each machine has two feeder tables, one is fixed, the other interchangable. Parts on both sides of the machines does not create a kitting problem but can be inconvenient for feeder replenishment. I have found "U" shaped lines to be much more operator
Electronics Forum | Thu Feb 26 10:27:43 EST 2004 | rob_thomas
We've been using it for a long time to inspect and measure paste height and it works very well.Training the operators is very easy and it is not a time consuming method.We also have an in line automated paste inspection cyberoptics unit and in some i
Electronics Forum | Fri Jul 22 10:30:43 EDT 2005 | Frank
I haven't heard of a meter like that. Consult Fuji for a recommended supplier if it is so special. The meter from Gates has a very sensitive microphone, so you tap (or strum) the belt and the vibration is heard and converted to Hz. If you want to
Electronics Forum | Mon Apr 17 14:08:51 EDT 2006 | russ
So far the only issue I have been able to determine with this product is Pkaymetals the company. Seems impossible to get samples or local representation. Was told first that they would not let me have it until they had local representation so equip
Electronics Forum | Mon Aug 21 10:47:48 EDT 2006 | FredC
Hello Mika, I just checked a windmill and a test nozzle we have on the bench. The useful travel of the nozzle before the risk of the crosspin getting stuck in the loading gate is 1.5mm, if it gets stuck it is the nozzle is 1.7 up. If the cross pin is
Electronics Forum | Tue Feb 24 14:08:46 EST 2009 | swag
I think you are too hot out of the gate as well as too slow on conveyor. I think settings similar to 130, 140, 150, 160, 230, 240, 260 and conveyor speed at about 28 or 29 IPM would be more realistic but it depends on your paste and oven config/zone
Electronics Forum | Sat May 29 02:26:14 EDT 2010 | vinitverma
If you want to vary the voltage to control the motor speed, then this is not the correct way. Though you can use LM317 for reducing the votage (using a 5K potentiometer) which will sure reduce the speed but it'll reduce the torque tremendously. For D
Electronics Forum | Fri Jun 24 15:04:22 EDT 2011 | kahrpr
I am going to open the flood gates of comments. The purpose of no clean is so you do not have to clean it. Yes I am aware of no cleans that you can clean. If you need to clean the boards use a water soluble paste. If you do not clean, no clean prop
Electronics Forum | Mon May 09 18:14:54 EDT 2016 | davef
I asked Randi Gates, Electrolube Marketing to join us to help with the conversation. Taking a step back from the Electrolube question, I could envision a 10 minute soak in DI water stripping the gold from a an ENIG board, you know, depending on the
Electronics Forum | Tue Apr 28 09:27:53 EDT 2020 | assuredtech
On power up, push and hold the F1 key during the complete boot up, this will force the machine to boot into it's I/O menu, this allows you to verify the conditions of all of the sensors and confirm if it is waiting on an input from a sensor. Most com