Electronics Forum | Tue Sep 10 14:27:12 EDT 2013 | ericrr
There is 8 nipples on the X-Y frame that is used to grease the frame, I was told these need to be greased often, as if the bearings go dry and break down it would cost big money to replace the bearing. (not sure how this price compares to other machi
Electronics Forum | Thu Mar 28 18:00:31 EDT 2024 | alexv
The tapping noise is what you hear when Hydra taps each tool on the tool bank to make sure the tips are seated well. The error is a Z-motor problem. The gear is at the top of the Hydra and needs grease. Have you cleaned the old grease and applied new
Electronics Forum | Tue Jul 04 03:15:00 EDT 2006 | dougs
can't you pull the leadscrew cover back? you usually can on fuji machines. pull it back and clean the leadscrew down then smother it with grease and manually run the axis back and forth a couple of times. then repeat until the grease is not discol
Electronics Forum | Thu Mar 05 19:44:08 EST 2020 | portersmt
Hello, Was hoping to hear from fellow users of the Samsung/Hanwha SM4xx series. We currently have an SM482 and we were hoping to do some much need maintenance on it. Specifically, we are wanting to clean and grease the X & Y LM rails and Ball Screw
Electronics Forum | Thu Mar 30 15:15:47 EST 2000 | M Cox
Does anyone have a contact whereas I may obtain this goop (Daphne Eponex Grease #2) it is recommended by the Royal Fuji manufacturer. MCox
Electronics Forum | Tue Mar 11 16:18:45 EDT 2008 | markhoch
We purchase our Biral T&D, Visco Grease, and NMT (No Melt) Grease from: Biral USA P.O. Box 878 McLean TX, 79057 ph (806)779-2700 fax (806)779-2543 Hope this helps!
Electronics Forum | Thu Sep 12 08:29:50 EDT 2013 | williamaxler
In my past we have used grease that we put in the connector before potting. The grease would keep the potting from flowing into the connector.
Electronics Forum | Fri Feb 21 17:12:43 EST 2020 | SMTA-Alex
Have you performed the maintenance? It might need grease, or there might be excess old grease, that's putting more friction on the Hydra Z. Check if there might be interference from the vacuum tubes or wires.
Electronics Forum | Fri Feb 21 18:27:23 EST 2020 | tomdegas
Thanks for the quick response. I’ll try it tomorrow and let you know if that worked. I do grease it but there may be residual older grease still there.
Electronics Forum | Mon Jul 12 17:52:18 EDT 2010 | warwolf
Hello Our company has just bought a EWS 500 F XL wave machine (about 8 months ago) and i have been trained on how to use it so in new to the industry, things are going well so far but im a bit stumbled on the simplest thing and that’s weather or not