Electronics Forum | Thu Feb 22 15:25:16 EST 2007 | russ
Hmm our table is steel. We had extra supports made at a machine shop, bought the magnets from the hobby store. we basically just had steel rods cut off at 1" lengths and had a counterbore drilled to glue magnet in Russ
Electronics Forum | Thu May 03 10:45:27 EDT 2007 | mmjm_1099
Make sure you check to see that they are not lead-free balling and using leaded profile. We had this and had continous problems. We had to send out our BGA to get reballed.
Electronics Forum | Mon Feb 04 11:39:51 EST 2019 | robl
No worries. From memory you could get 2 types of head - 1 where you had grippers and the other where the head held the whole panel. We had interchangeable grippers. Also had some Cencorp 1000 & 1300BRs which were ok, but not sure on Global support
Electronics Forum | Tue Feb 03 12:39:20 EST 2004 | paul_bmc
We had the data at the time and it was quite high. More false calls then anything. I do not have the data anymore it since has been archived. When the system was introduced we had 1 engineer and 2 operators trained for programming and running the
Electronics Forum | Tue Apr 13 21:33:48 EDT 2004 | qualitel
Hi Dreamsniper, It seen this is the major issue had been occurs you.( We had face all this issue last time too) We had done a lot of areospace products before and most of ours products is a must on class 3 spec. BGA is not that tough t
Electronics Forum | Thu Apr 12 01:23:04 EDT 2001 | Eric C
Check the pad size. I had this issue before due to the pad size too wide. R&D had change the size of the pad and is solve the issue. Before the pad size change, I had rebuild another stencil with the pad opening close to the component size. It won't
Electronics Forum | Tue Feb 08 12:57:42 EST 2000 | Travis Slaughter
I have had the exact thing you describe happen to me, at least it sounds the same. On the PLCC there could be maybe 1 leg not soldered or many of them tending to be in groups but not necessarily. This happened on a established board that had always
Electronics Forum | Wed May 20 08:38:51 EDT 1998 | Jerry
We have had really good luck with the IIT version. We use it with a DEK265 also. I am having trouble coming up with a brochure but their email address is iit@ns.net. We have ordered probably 10 to 15 stencils for use on prototype builds. We have
Electronics Forum | Wed May 08 08:45:29 EDT 2002 | pteerink
I have used the benchmarker for solderpaste evaluations, and had very good results. Best results I had were in evaluating the spread, slump and wetting of the pastes. ( of course that is where I had the biggest issue too ) If you are looking to eval
Electronics Forum | Wed Oct 12 14:13:08 EDT 2005 | Inds
SN100C is the Nihon solder. I had wave solder the board using SAC. Then had to put on solder pot, which had SN100C (nihon) solder. I think I went upto 130-135 deg C.. Let me try cooking it to 150degC Thanks
