Electronics Forum | Wed Feb 25 21:37:12 EST 2015 | dinhhuunam
Hi Bartel , 1.1 Profile Solution to Cold Soldering Cause for Cold soldering The peak temp of reflow is too low. The preheating temp is too high and it takes too long Solution Lower the preheating temp and increase the peak temp in the reflow zone
Electronics Forum | Wed Aug 30 07:18:27 EDT 2000 | russells
Can you use 96s solder wire on a pcb that has been plated with standard 60/40? if so what are the effects on the proerties of the 96s? If you cannot mix the two solders is there a more effective way than braid of removing the 60/40 from the plating?
Electronics Forum | Wed Sep 03 20:51:35 EDT 2003 | davef
Dunno about UK suppliers, how about: * Isola P97 / P27 * Polyclad GI-787 If laminates are so bloody expensive in UK, why not them have made in the States?
Electronics Forum | Fri Aug 29 05:48:57 EDT 2003 | russells
Can anyone help? We need a PCB material capable of working at 200 deg C, we are currently using Norplex P95 but we are being stung with huge minimum order quantites as we are in the uk and all the manufacturers have to buy it in on special order. Doe
Electronics Forum | Wed Aug 30 16:00:42 EDT 2000 | Dave F
Russells: You can mix the two solders you mentioned, assuming by "96s" you meant "96Sn / 4Pb". If you heat the two tin / lead alloys to a liquid state, you�ll form a tin / lead solution with properties different from either of the two solders. The
Electronics Forum | Wed Nov 28 06:06:18 EST 2018 | msbettyhunt
Even, proportional–integral–derivative (PID) algorithm works well in this case.
Electronics Forum | Wed Dec 12 07:59:07 EST 2018 | mermarinc
@BettyHunt, thanks for sharing.
Electronics Forum | Tue Oct 16 10:06:41 EDT 2018 | emeto
Hello experts, I have an assembly that goes through pretty tough sterilization on regular basis. Currently I am using a two component material in potting process. I was wondering if you can help me with material that can handle high temp and humidit
Electronics Forum | Thu Nov 01 12:52:18 EDT 2018 | emeto
Thanks Rob, It looks like my customer wouldn't let me to change the material. However, this potting material still sticks to the non sticking fixture that I have. Can anyone give me a non sticking material that I can make these fixtures out of?
Electronics Forum | Tue Nov 27 08:40:24 EST 2018 | ethanscott
I don't think could suggest anything different than what Rob has suggested. It's really nice to have such information. Thanks, Rob for sharing it.