Electronics Forum | Mon Jun 25 12:23:15 EDT 2007 | davef
Once the HumiSeal conformal coating has been applied to the printed circuit board it is usually best to allow the material to reach a touch-dry stage, before heating the board to accelerate the cure schedule. This avoids potential problems such as bu
Electronics Forum | Thu Nov 23 23:59:25 EST 2000 | terry sun
Hello to all out there, We're considering CC process,and would like to know some defferences between SSC3 of Electrolube and Humiseal 1B73, yes,I know that SSC3 is silicone one,and Humiseal 1B73 is solvent based acrylic as well as other basic propert
Electronics Forum | Tue Nov 28 13:21:33 EST 2000 | Graham Naisbitt
Terry The SCC3 product is a vinyl modified silicone. It is less able to perform at low temps as it becomes brittle. It is not easy to repair because it is essentially silicone. It is not a qualified material to the MIL-I-46058 Spec. Are you sure yo
Electronics Forum | Tue Nov 08 17:06:26 EST 2005 | Erik
A while ago I tried using rubber boots for masking but couldn't get them to work because the coating we use (Humiseal 1B73) is so thin it leaches under the rubber. If you can get them to work with your application more power to ya.
Electronics Forum | Sun Nov 29 20:04:05 EST 2009 | prodivegsr
Hi sforman1, The chemical that i'm using is a solvent based coating humiseal 1B73. From my understanding,the UV curing is mainly for UV curable coating like the UV40. And the main advantage of using UV curing is for fast throughput and environment
Electronics Forum | Thu May 31 14:59:50 EDT 2012 | jdumont
I use Trace and certainly recommend them. I actually just had this test done last week. Adhesion test per ASTM-3359 Method B. We use Humiseal 1B73, which is similar to what you use. Is your soldermask "active" enough for this coating? I believe
Electronics Forum | Thu May 31 15:00:33 EDT 2012 | jdumont
I use Trace Labs and certainly recommend them. I actually just had this test done last week. Adhesion test per ASTM-3359 Method B. We also use Humiseal 1B73, which is similar to the 1B31 you use. Is your soldermask "active" enough for this coat
Electronics Forum | Wed Oct 17 02:04:39 EDT 2018 | robl
SCC3 has an operating temperature of 200C, as long as it is heat cured at 100C. https://www.electrolube.com/pdf/tds/044/DCA.pdf It's also a silicone so needs to be coated & cured away from anything you value. Otherwise there are plenty of PU's and
Electronics Forum | Mon Feb 18 18:13:30 EST 2019 | slthomas
Has anyone found a durable, indelible inspection stamp ink? We have an extreme case of smearing/obliteration because we have the boards dip coated (Humiseal 1B73). The manufacturer of our stamps is zero help, i.e., the best I could get out of them
Electronics Forum | Wed Jan 27 09:00:56 EST 1999 | Chris Fontaine
| | I have boards coated with Humiseal 1B73. At a late point mfg. site we need to remove a series of 0603 resistors for optioning purposes. I have been trying to determine the fastest, easiest way to re-coat the pads after removal. Drying time of the
