Electronics Forum | Mon Dec 17 14:16:44 EST 2007 | realchunks
This is funny. Poeple giving answers to a question that isn't specific. What if the shorts he is having are on the top of his board, caused by flooding or Omega wave too high?
Electronics Forum | Mon Dec 17 12:06:58 EST 2007 | pjc
5 Steps to Eliminate Bridges: 1. Establish (wave) Parallelism First and foremost, you must establish board-to-wave parallelism. This is the prerequisite to any wave solder process control. For an understanding of the power of this approach go to ht
Electronics Forum | Sat Apr 07 00:41:35 EDT 2007 | Haris
Thank you all for giving me good knowledge.
Electronics Forum | Mon Dec 17 13:58:54 EST 2007 | ck_the_flip
I made my own wave measuring device using KIC2000 system. KIC2000 has automatic wave detection, so now I have a profiler for both reflow ovens and wave solder. The delmat carrier only cost $500. A guy, Samir, from this forum gave me the idea, actu
Electronics Forum | Thu Jul 06 12:52:35 EDT 2006 | samir
..and he can put the flux in and keep it a secret too from his customer.. RSS profile on wave?? I never heard of a soak zone for wave preheat...you may be burning off your activator..hence, the beads. For wave preheat, your main goal is to ramp up
Electronics Forum | Mon Dec 17 11:55:08 EST 2007 | chef
I recently had the same problems, solder bridges on every thing I made, different customers boards, etc. I wave with no-clean flux. As I sorted out problems (pin holes, blow holes, splatter, etc.) I found a lot of variable factors. I changed flux,
Electronics Forum | Thu Apr 05 08:44:45 EDT 2007 | ck_the_flip
"Guest" is right, actually. CSP's are essentially BGA's, but typically the pitch and ball diameters are much smaller and in some cases, the pads of the CSP's can not be screen printed. If that's the case, you'd have to have flux-dip capabilities on
Electronics Forum | Thu Jul 06 03:03:56 EDT 2006 | ronalds
Thank you all for your input. The MF300S Multicore flux is rated for lead free. There is not much dross or contamination. We are using nitrogen. I've tested the boards with the curing test of IPC-TM-650. I think you're all right about the preheat.
Electronics Forum | Wed Apr 04 18:27:53 EDT 2007 | Guest
Most CSPs are BGAs. Some are sent without bumps or balls. Thjos eneed to be bumped prior to processing for best results
Electronics Forum | Fri Apr 06 01:10:16 EDT 2007 | Haris
My SMT line does not has these facilities so would you please tell me regarding the UNDERFILL AND FLUX-DIP process and how they can be done? Thanks.
.gif)
