Electronics Forum | Tue Sep 03 14:18:49 EDT 2002 | dragonslayr
Jersbo- I will refer you to the late, Great Mark Twain, who once wrote: "There are 3 kinds of lies in this world - Lies Damn Lies and Statistics"
Electronics Forum | Wed Oct 23 10:45:00 EDT 2002 | genny
Some of the posts lately seem to have little open rectangles where the punctuation marks would be. I'm just wondering whether that is what Steve was talking about. They can look a bit like zeros, albeit squared off.. It makes it hard to read.
Electronics Forum | Thu May 08 18:49:47 EDT 2003 | slthomas
Russ, Some people don't look into those details. They get into trouble and decide they need to make cuts. Labor rates are the first thing they jump on because there's such an obvious gap between Chinese rates and the rates here. Details, such as t
Electronics Forum | Mon Dec 16 21:35:46 EST 2002 | grantp
Hi, We tried AIM no clean, and one other paste which I cannot remember the name offhand. We have been using Koki lately, and that's been the best. It seems to leave less residue behind in the stencil. Regards, Grant Petty Blackmagic Design
Electronics Forum | Mon Jun 21 07:00:16 EDT 2004 | N.Berkhoudt
May be a little late for you, but we experienced the some problems with decouple 100 nF C's. Siemens has reported problem in production in november 1998.
Electronics Forum | Fri Feb 27 07:48:34 EST 2004 | mk
Sorry I am late with the solution but I have been out on the road. Absolutely the reason solid solder deposit was invented. Hands down the best and most affordable, dependable solution to your challenge. http://www.sipad.com mkehoe@sipad.net
Electronics Forum | Sun Mar 21 11:01:07 EST 2004 | bgt
I know this response comes late, but my advice is to get your paste supplier in for some good profiling time before you decide how to do your own. My paste supplier will come in on a moments notice if I need them.
Electronics Forum | Tue May 11 10:43:37 EDT 2004 | Melissa
Has anyone experienced problems lately with excess flux residue left on the board after reflow when using Alpha UP78 OSP paste? We are getting a component failure that the designers are blaming on too much residue. Thanks
Electronics Forum | Sun Jun 20 07:12:40 EDT 2004 | Grant
Hi, Anyone using the Sony TiMMS software? I am thinking about heading up to Taiwan late June, early July for the equipment show, and I wonder if anyone's going to be showing it there. Has anyone got experience running this software? Regards, Gra
Electronics Forum | Mon Aug 02 10:20:39 EDT 2004 | MikeF
You might also want to check out the web site for Assembly Magazine. I have not checked it lately, but they used to have several technical articles about fasteners there. It is http://www.assemblymag.com. Mike F