Electronics Forum | Fri Sep 28 10:04:14 EDT 2012 | dwelch123
Looking for some help. I'm getting no power to the main machine. All power supplies are getting correct power in but not outputing power. All output terminals on power supplies read 0V. The main transformer outputs all check with proper voltages. At
Electronics Forum | Wed May 19 17:54:41 EDT 2010 | gregcr
I have had problems corrected by swapping or replacing the power supplies in the box. Do you have a second GSM that runs the AIS3500 box? If so swap the power supply and see if the problem follows the swap. I have replaced the supplies inside the
Electronics Forum | Thu Feb 06 14:01:55 EST 2014 | rgduval
1. Fuse 2. Power Supply 3. Power Distribution card 4. Booster Start by checking all of the fuses on the front of the power supply (accessed by removing the front cover of the machine). Then, check all of the fuses on the first card in the MOT bay.
Electronics Forum | Thu Feb 07 18:19:38 EST 2008 | mobytahoe
We are experiencing corrosion and subsequent pcb contamination from the RTV material used to secure a Power Supply. The degradation takes place over a few weeks. The power supply vendor is balking at liability, our OEM customer is screaming. Anyone
Electronics Forum | Sun May 02 11:41:04 EDT 2010 | bruceb
My DEK 265GSX will not boot in the mornings. When I check my power supplies 5 volts is measuring 1.6v. When I disconnect 5v I read 5.3v on the power supply. When I reconnect to the power supply the problem goes away. Has anyone seen this problem and
Electronics Forum | Wed May 19 16:48:23 EDT 2004 | SWagner
You might have something dragging down your power supply, I have had the color monitor do this when it approachs the end of its life span, I have also had the power supply itself go bad but the voltage is usually 0. Unplug the monitors and see what
Electronics Forum | Mon Sep 19 04:27:47 EDT 2005 | dougs
Check your power supplies, we had same fail a while back on VIP98 faulty power supply was the cause
Electronics Forum | Thu Dec 07 00:41:19 EST 2006 | bigdaddysoy9
Hello SMTnet, I would like to make a power supply for Universal multi pitch feeders so I can index them offline. How much voltage do I need to get to what pins of the connector? Thanks.
Electronics Forum | Thu Feb 15 12:45:44 EST 2007 | chrisgriffin
If you think you are having lighting issues, you should do a histogram test. It's under the test user. There is a pot on a power supply that will adjust the brightness. The power supply is right next to the Y axis motor. There should be a brown p