Electronics Forum | vsuresh |
Fri Mar 22 09:56:16 EDT 2024
Electronics Forum | Mon Dec 06 20:58:34 EST 2021 | erici
Hi victor, The power supply of the machine is giving us problems now, and so i cannot access anything at the moment. While working on the machine, the power on the machine suddenly started flickering and was causing the pc to shutdown as well. Have
Electronics Forum | Wed Jan 30 11:27:44 EST 2013 | ericrr
----- More ------ Due to the need to keep to run going while waiting fo the repair joker to emerge, are doing the run on just two machines.It turns out that when the faulty machine has been left on for two hours the fault disappears and the machine w
Electronics Forum | Sat Aug 08 09:45:11 EDT 2015 | edwaterfall01
It would be helpful to know what happened before the error occurred. Do you have another machine so that you can swap some boards? The Force CPU, (machine controller) located in the VME, is responsible for controlling all machine-related activities.
Electronics Forum | Wed Feb 23 13:50:55 EST 2005 | c.b
I am currently using a quad 1000, and up to now it has been a good reliable machine upto yesterday. I now have an error message that reads "driver error, emergency stop" the machine then freezea and will not run. Could some one please tell me if t
Electronics Forum | Sun Oct 11 10:00:11 EDT 2015 | brockparry
if you are facing a problem to send the data to your machine then you must check the driver part of your machine if you are sending it through any software. Also check the power status of the machine. You can also go for one simple method by doing Re
Electronics Forum | Thu Aug 18 02:39:21 EDT 2016 | epsltd
We have a Mirae 1030 and when the machine warms up the y-axis fails and we are unable to reset servos unless we leave machine powered down few hours. Now since we have changed servos after machine homes we jog the y-axis and it vibrates and very nois
Electronics Forum | Tue Aug 04 12:11:56 EDT 2015 | bnorton
OS/2 UIC version 3.2.3 Powerup seems to go OK until, while the GUI says ...initializing..., an error popup appears saying "Did not receive request to load machine model within timeout period. Possible machine error condition exists. Do you want t
Electronics Forum | Mon Dec 06 21:07:36 EST 2021 | victorzubashev
Hi, you have flickering that affects all AC power in the machine (PC is also connected to the AC line (after step down transformer)), correct? Do you intermittently/randomly lose power in all machines units(MC/PS/Servo)? If I understood you correctly
Electronics Forum | Tue Nov 27 09:46:40 EST 2012 | jaimebc
Interesting, it seems the theta error followed the ZFIB board, running the machine with the original theta error and using the ZFIB board from the second machine since Thursday, no errors since...will continue to evaluate and post results...