Electronics Forum | Tue Feb 29 21:18:00 EST 2000 | Gwen Z
When an assemblied board was on active service, what's the main reason for its failure:the package broken; the mechanics fatigue failure under thermal cycle; the corrosion caused by salt and vapor; the broken chip inside the package etc. I think all
Electronics Forum | Fri Apr 26 15:00:44 EDT 2013 | leemeyer
This is what the manual says about this message : Power Failure Detected A main power failure occurred and the machine is being powered by the UPS. All heaters are shut off immediately ad the conveyor clears all boards If main power is not restored w
Electronics Forum | Wed Dec 08 18:22:47 EST 2004 | msjohnston1
Here is a list of companies that have solder paste inspection equipment that use a laser for measurements www.gsilumonics.com www.orbotech.com/products_assembly_main.asp www.fa.panasonic.co.jp/products/smt/inspection/main/ipm_e.html
Electronics Forum | Fri Aug 08 11:39:33 EDT 2008 | ethancw1sel
Thanks for your input. I too thought the pogo pins would be the main issue. But we've been running with ours for about 6 months, and we've not replaced one pogo pin block. But we've replaced 4 or 5 various sensors. The PSV and Tension sensors are
Electronics Forum | Fri Sep 28 10:04:14 EDT 2012 | dwelch123
Looking for some help. I'm getting no power to the main machine. All power supplies are getting correct power in but not outputing power. All output terminals on power supplies read 0V. The main transformer outputs all check with proper voltages. At
Electronics Forum | Tue Oct 01 05:10:20 EDT 2013 | anilw2006
Please go to output from I/O option and press on/off option in the main conveyor. While on condition motor should on when off motor should stop.If this will not happen then need to change I/o card.
Electronics Forum | Wed Jul 09 18:25:32 EDT 2008 | jmelson
There are temperature controllers that can be configured for a "safety stat" mode, so they blow a fuse to the main heater control if it goes, say, 10C or some reasonable fluctuation above the setpoint. It might be a VERY reasonable thing to add to y
Electronics Forum | Thu Oct 21 10:14:29 EDT 1999 | Larry J
Brian, my main conceren was it evporating once it was printed on to the board before placement.
Electronics Forum | Tue Sep 29 16:47:41 EDT 1998 | Clifford Peaslee
Just verifying that I can post to the main listing. Cliff
Electronics Forum | Tue Aug 20 13:27:09 EDT 2002 | cnoonan
I am mainly needing information on SMT pick and place equipment.