Electronics Forum | Fri Aug 06 09:27:29 EDT 2004 | Bob R.
It depends entirely on the machine. Different machines use different mechanisms and control methods.
Electronics Forum | Thu Aug 05 11:40:24 EDT 2004 | Dhanish
How do you perform stackup analysis for mechanical parts?I refer to some documents and it is very detail.
Electronics Forum | Thu Feb 17 14:42:52 EST 2005 | gregp
I would first check the alignment of the flux capacitor to the roto pluker mechanism.
Electronics Forum | Fri Apr 01 09:40:57 EST 2005 | russ
Doug you are correct, I was talking about the integrety of the surface for mechanical measurement accuracy, not ESD properties.
Electronics Forum | Tue Nov 08 16:24:17 EST 2005 | cguerrero
Are your rejections due to mechanical, electrical or hydra vision errors?
Electronics Forum | Mon Jan 09 19:28:45 EST 2006 | KEN
If you're the type to inquire (and truly care) about FPY then mechanical centering is NOT for you.
Electronics Forum | Fri Jan 20 07:51:17 EST 2006 | davef
John Kania, 202-962-0400 or e-mail JohnKania@ipc.org.
Electronics Forum | Thu Apr 20 14:37:29 EDT 2006 | Chunks
The newer MPMs use the camera to find the board edge - no mechanical stops like AP and DEKs.
Electronics Forum | Thu May 18 17:34:06 EDT 2006 | Frank
The Juki tape feeders are mechanically actuated. There is a knock pin on the bottom of the feeder bank that will push up to advance the feeder.
Electronics Forum | Wed Feb 21 12:40:07 EST 2007 | cyber_wolf
What type of Mydata is this ? TP or My series ? Optical or Mechanical centering ? How many hours are on the machine ?