Electronics Forum | Fri Nov 23 15:46:06 EST 2007 | mika
Question: We have an issue right know on a prototype batch with via in the pad on an very small pcb 50x50mm (in a panel of course). The designer has no room to move the vias as they said. The pcb is to packed with components also 8-layers. It is also
Electronics Forum | Thu Jun 05 21:59:22 EDT 2008 | mika
bsumfg, The very best anybody said lately!! This should go straight into the the manual! I totally agree with you; Just an add: The fid's should never be mistaken for a test point who normally is between 1.0 - 1.27 mm so make the fids 1.5 mm. round
Electronics Forum | Wed Jul 02 20:39:13 EDT 2008 | mika
Check this out .http://help.sap.com/saphelp_di46c2/helpdata/EN/7f/a7e7434d6011d2b438006094b9c9be/content.htm That's one way how to do it. Or read this: http://www.waterloo-software.com/limitations.html We have no relationship or what so ever with
Electronics Forum | Mon Jul 20 23:06:49 EDT 2009 | mika
10 or even up from a UIC conveyor of the old model - probably SMPI is the connector from UIC fully loaded, then full SMPI, but not all of them are used. Just Good board, bad Board, send, receive acknowledge. It is possible to convert this into SMEMA.
Electronics Forum | Thu Feb 04 04:28:52 EST 2010 | mika
You don't by any chance have a s/w called Motion Control s/w? it's on 1-2 floppy diskettes and it will boot from it also. Normally only the UIC field engineers have/has? this. With this we can actually run each axis & valve or whatever independentl
Electronics Forum | Sun Oct 30 03:55:43 EST 2005 | mika
I apologize for my poor english. First: "Double sided sticky tape" is excellent for various reasons; right/left?. Second: NPI? Don't hesitate, If You feel that a certain machine in Your line cofiguration don't place certain/certain's components on th
Electronics Forum | Sat Sep 22 02:14:08 EDT 2007 | mika
Another thing to make sure of and the vision calibration system will fail if this is out of range: Use a magnet foot stand micrometer and measure the spindle run outs. First remove the nozzles and nozzle adapters, then put the adjustable tip (I dont
Electronics Forum | Fri Oct 05 21:29:43 EDT 2007 | mika
Hussman, I don't understand the last sentence of yours "but far from where this thread was going". What do you mean with that? I was just trying to give "Novaman" some infos. The fine old equipment You use from the old -20:s or so, is probably just a
Electronics Forum | Sat Nov 10 21:15:04 EST 2007 | mika
make 4 square rounded corner apertures around the ground pad and the total reduction of 20 % (80 % solder paste). Then you still be able to solder the terminals around. We SMT-mount & reflow soldering various QFN packages onto our customers pcb:s wi
Electronics Forum | Sat May 17 18:53:56 EDT 2008 | mika
I would suggest You to Contact UIC S/W development department in Germany and ask for Peter Raab. European Headquarters � Neu-Isenburg, Germany Phone: +49 (0)6102-8822-0 Normally I guess that one asked such a question here, just because of not to be