Electronics Forum | Mon Feb 02 14:06:27 EST 2004 | jsk
I did reload mint. When i do this the machine runs fine for about 15 minutes, but i have to continue loading boards. If I let the machine idle for 3-5 minutes, i get the error. We are a low volume manufacturing company, so on a 20 piece run i will re
Electronics Forum | Thu Sep 25 16:23:42 EDT 2008 | aj
Hi, Have you tried to download the MINT ?if this works you should be back in business , if not,check your PSU, which you can access from the back? check the manual as to which one powers the cards- dont have manual to hand but I think it is the 5v
Electronics Forum | Fri Sep 26 08:11:15 EDT 2008 | dwelch123
Try swapping cards in Y1 enclosure. You can swap zero and one or two and three but make sure you change the shunt position and the dip switch settings and see if your problem switches cards. The lithium battery likes to fail on those cards. Reload th
Electronics Forum | Mon Jan 06 16:19:32 EST 2020 | richardcargill
haven't tried the MINT as it won't let me get that far !! Swapping the Eproms with card 1 and changing the identifier will let it get to the 'Press SYSTEM key' part of the startup though, then it fails on card 1 instead of 0 so I'll give that a try i
Electronics Forum | Thu Oct 10 03:18:28 EDT 2019 | bukas
Hey guys, my DEK265 GSX is acting funny. It misprints half of the boards. The one half when squeegees move away from operator to be precise. When squeegees are moving towards operator print is perfect. In both cases actuators are moving prior to prin
Electronics Forum | Thu Sep 22 18:47:08 EDT 2011 | rodrigo
Hi all, We just got this machine and it is not fully functional. I read somewhere here that the folder mint has some useful stuff. I run mint and it said that it cannot communicate with card 0,1,2,3 (x1,x2,x3,x4). It said to make sure the cards are
Electronics Forum | Tue May 27 15:11:13 EDT 2014 | dekhead
1. Rising Table Position error is, most commonly an issue of motor movement or sensor(s); Not receiving an expected input (sensor input / 'DONE' signal) in expected period of time. Try homing table in Diagnostics see if it moves and what movements ar
Electronics Forum | Sun Sep 25 16:40:09 EDT 2011 | cbroegger
Have been through the same problem with the eurostep cards. The missing communications with the cards, suggest that some acid leaked from the batteries have etched tracks/and or the serial converters (soic8) on the cards. In all cases, clean the card
Electronics Forum | Thu May 16 04:54:33 EDT 2013 | aj
Hi all, I have an intermittent problem on a 265 GSX printer. "Position error" on the rising table.. quite a lot of work has been done with no success. such as motor, break , encoder replaced....diagnostic checks etc.... Machine could run for a few
Electronics Forum | Tue Mar 22 13:00:37 EDT 2022 | bukas
hi, I have a 265GSX machine that prints firs PCB in batch correctly and then missprints the rest(there may be acceptable prints by accident). after hitting END RUN and RUN again, first PCB comes out perfect but others are bad. paste is randomly shift