Electronics Forum | Fri Feb 18 08:49:22 EST 2005 | Mark
This is brutal. O.Tarango, I think the techs on this forum need a bit more detail from you. There are only a million or so possibilities why your components are being mis-aligned.
Electronics Forum | Thu Dec 08 03:22:34 EST 2005 | khp_armin
Please give mesome guidelines for our pick and place machine (Juki)because we always encounter mis-alignment and missing components.
Electronics Forum | Fri Jul 21 12:04:09 EDT 2006 | CKH
Hi Folk, recently, i have faced some issue on Components Misaligned (1 pad size way). What could have cause this issue... Thks & Warmest Rdgs CKH
Electronics Forum | Thu Nov 16 14:35:50 EST 2017 | sambolian
I have an issue with our Mirtec MV-7xi AOI machine where it's detecting all misaligned parts as missing part. Even when i manually select "Misaligned", it still populates the defect as missing. See attached file for example.
Electronics Forum | Thu May 14 16:09:49 EDT 2015 | hottchkisu
Hi All, > > On occasion we see components that > have gone through pick and place and are slightly > misaligned. Currently, operators manually adjust > these misaligned components to prevent reflow > failures. However, I am wondering if this >
Electronics Forum | Mon Apr 23 07:19:23 EDT 2001 | dahsr
Can I have solder bridging two SM rectangular chip components due to misalignment? The bridging occurs at one end and is on a common trace between the two pads. The components are larger than the pad (side overhang) and are aligned rather perfectly w
Electronics Forum | Wed Apr 29 17:51:44 EDT 2009 | smt_guy
One more thing: I have a Panelized PCB with 8 boards on the X directions. As I move to the next PCB towards the right my misalignment moves to the right by 0.02mm. By the time I reach the 8th PCB I'm Off by between 0.12mm to 0.14mm. My fine pitch
Electronics Forum | Fri Jun 03 07:28:14 EDT 2011 | denz34
Hi there, I have questions regarding on SMT RF Shield dewetting & misalignment issue.. Q1) How to identify on good or bad RF shield that could contribute to dewetting? Q2) What counter measure that must be taken when facing dewetting issue? Q3) W
Electronics Forum | Fri Apr 22 18:17:14 EDT 2022 | swilson
Hello I experiencing major misalignments. I am using a Nichia LED package size@ y=.086,x=0.33mm, with recommended solder pad pattern x.086mm, y=.033. Note here is the kicker the PCB pattern does not meet this requirement. The PCB pad landing is based
Electronics Forum | Thu Nov 18 11:13:34 EST 1999 | Dave F
Thomas: Thanks for closing the loop. Dave F