Electronics Forum | Wed Aug 23 09:27:41 EDT 2017 | dleeper
As Evtimov mentioned, it will be dependent on package. It will also be dependent on the specifics of your machines so there is no universal "good" value. You will need to experiment to find the best values for your equipment and components. I would
Electronics Forum | Thu Mar 08 06:57:28 EST 2018 | davidportercpl
I'm struggling to place cylindrical components on the Panasonic AM100, melfs in particular. I have just about goet around the recognition side of things, but pickups are hit and miss, and placements are not very consistent at all. Currently using a 2
Electronics Forum | Thu Nov 17 14:33:02 EST 2011 | olddog
Thanks again Bobpan for all of your help. I hope some of my questions are dumb ones. Regarding "first", the QA error 0, you were right. In checking the setup, for some reason theta was 65227 instead of the 0 that I thought I had set. Regarding "sec
Electronics Forum | Wed Jul 09 14:47:39 EDT 2014 | deanm
I'm looking for a typical SMT placement defect rate from others in the field so I can judge whether or not we are in an acceptable range. If I give you a board with 200 components (0603, 0805, SOICs, 20mil MSOPs, tantalums, DPAKs and a few 20mil fin
Electronics Forum | Wed Oct 06 08:55:23 EDT 1999 | Brian Conner
| | I hope that someone can help me with my problem! I am experiencing a lot of glued on parts falling off in the wave solder machine. A little information about my process: 1)We use Loctite 3609 glue that is used up long before its shelf life 2)Ou
Electronics Forum | Wed Oct 06 11:41:50 EDT 1999 | Bill Haynes
| | I hope that someone can help me with my problem! I am experiencing a lot of glued on parts falling off in the wave solder machine. A little information about my process: 1)We use Loctite 3609 glue that is used up long before its shelf life 2)Ou
Electronics Forum | Tue Jan 28 16:47:31 EST 2020 | jede
We are running a Juki SMT line (3RAL and 2080E). I am not sure there is an option for a component verifier. My thought is a barcode/scanner set up and I am in the process of working on this but waiting on Juki response on a file question. We do use
Electronics Forum | Fri Sep 02 14:15:44 EDT 2005 | Mika
Check the dimensions of the components in question with a caliper and put the correct numbers in Your part data. Check that the correct nozzle is being used. Also make sure that you have the right pcb height in Your program. This is somewhat criti
Electronics Forum | Thu Sep 29 05:37:56 EDT 2005 | dougs
for 0402's you should be able to run the turret at full speed, if you need to slow it down it means that your machine isn't set up properly. use the vision number that the manual tells you and make sure your feeders are properly calibrated, poorly c
Electronics Forum | Tue Sep 27 15:57:43 EDT 2005 | stepheniii
Ceramic caps are denser than most other components and I"ve found the tops can be slightly rounded. You may want to slow down the turret speed for some parts. Do you ever get a location where there should be a part but there is not? If the part fly