Electronics Forum | Fri Jul 26 07:21:07 EDT 2013 | falvarez
thanks!! confirmed!
Electronics Forum | Thu Sep 25 09:56:23 EDT 2008 | mysmt
Hello, we are using DEK265gsx printers, at the minute ARCOM unit is not communicating with motor control cards 0,1,2,3 in Y1 enclosure. Checked CPU & RS232/485 cards from other DEK265, found okay. Any help will be appreciated. Mysmt
Electronics Forum | Wed Oct 13 17:05:02 EDT 2004 | kmakiya
I have seen stepper motors chatter or vibrate when it has lost one of its phases. You've replaced everything but the cable so I think you are right that it should be checked for an intermittent connection.
Electronics Forum | Thu Apr 18 15:33:37 EDT 2013 | empac
Hello, Does anyone know how to fix the following problem on a DEK265GSX? Motor comms failure card1 AX123 Fatal error re-initialize machine. Appreciate your help! Bob
Electronics Forum | Thu Aug 23 09:44:09 EDT 2018 | midware
Hi. Please help. On DEK 265 GSX i've got on the monitor message: "DEK 265 GSX Motor comms failure, card 1, axis 123 fatal error." F1-F8 doesn't work, machine cant start. No result after Reinitialise machine. Which one is this card1? Is it in PC?
Electronics Forum | Thu Jul 25 23:21:40 EDT 2013 | dekhead
1000ct encoder is the only one used on DEK Horizon (Typhoon Series); 2 different manufacturers, but interchangeable. http://www.dekhead.com
Electronics Forum | Mon Oct 11 17:06:55 EDT 2004 | M Deren
We have a DEK 260 with a intermittent table align stepper motor problem. The machine will work fine for awhile and then one of the table align motors starts either moving haphazardly in small increments back and forth or vibrates as if it wants to mo
Electronics Forum | Mon Oct 18 10:55:17 EDT 2004 | DenisM
Check the ground plane for noise with a scope. Steppers are very sensitive to spurs and will step in response to noise. Resistance welders on the same ground loo[ can be a problem as can seam sealers etc. Denis M Manncorp
Electronics Forum | Fri Sep 26 12:26:16 EDT 2008 | dwelch123
Isn't that what I just said? Read it again. I said you can swap zero and one OR two and three.
Electronics Forum | Mon Oct 11 17:02:06 EDT 2004 | M Deren
We have a DEK 260 with a intermittant table align stepper motor problem. The machine will work fine for awhile and then one of the table align motors starts either moving hapazardly in small increments back and forth or vibrates as if it wants to mov
