Electronics Forum | Thu Dec 03 14:30:36 EST 2015 | proceng1
That's what I was going to suggest. At one point we had 6 SM100s and I've replaced that power supply a few times.
Electronics Forum | Fri Jun 04 10:29:42 EDT 2004 | gregf912
Check ATS at WWW.ATS-SMT.Com for support on any Fuji and MPM machine in the US.
Electronics Forum | Mon Feb 12 09:06:18 EST 2018 | griinder
Thanks for the reply. I will try that. So is it normal for the live vision to be a mirrored image of the board?
Electronics Forum | Wed Feb 14 09:27:17 EST 2018 | cyber_wolf
On AP machines it is possible to mount the camera 180 degrees out. Not sure if this can happen on Accuflex.
Electronics Forum | Mon Mar 05 23:41:23 EST 2018 | 3l3ctro
Would like to know if you were able to resolve this issue?
Electronics Forum | Fri Mar 26 06:58:06 EDT 2010 | ristikas
Hello, We have here very oftenly one error in our MPM Accuflex. I dont know who to ask about that errors... The error is „The transfer light peam interlock has been broken. Remove the obstacle from the path of the beam.“ I checked the sensors and
Electronics Forum | Wed May 13 15:26:45 EDT 2015 | cyber_wolf
We are high mix - high changeover aerospace manufacturer. We have 3 1809 MK3 air ovens. There has been absolutely no issues with them. We have 4 MPM Momentums. I looked at DEK but felt the MPM's were put together better. They are very easy to use
Electronics Forum | Sat Feb 10 10:08:04 EST 2018 | griinder
We recently acquired used MPM Accuflex. Immediately I noticed the live vision is mirrored. This makes it incredibly difficult to teach fiducials. I noticed some smudges on the lens, which leads me to believe the camera assembly was "worked on" at som
Electronics Forum | Tue Mar 30 06:27:22 EDT 2010 | ristikas
It happens on the middle of the stecil cleaning. The camera and the cleaner will stay under stencil in half way back. Then machine asking the initate the motors. If to press initate then the pcb stopper will hit the rails. Usually we move camera and
Electronics Forum | Wed Mar 31 04:43:52 EDT 2010 | accuspares
If you dissconnect the crash beam sensor one at a time at the front leaving the remaining one connected you’ll be able to identify what side is causing the problem. Then you will be able to hopefully remove the object or adjust the position of the be
