Electronics Forum | Tue Dec 09 11:40:38 EST 2008 | dwl
Hello, I have an MPM AP 25 and the camera parks itself over the worknest, so when the z tower tries to rise to print, it collides with the camera. Is there some way to adjust the park position so that the camera in not in the way of the Z tower? Than
Electronics Forum | Mon Sep 21 12:15:55 EDT 2009 | swag
Can anyone tell me the correct DIP settings and jumper positions for a MpM AP25HiE Z-axis driver card? Thanks-
Electronics Forum | Tue May 05 16:19:15 EDT 2015 | brantco
Hi Everyone i am looking for a manual for a printer i picked up its a Speedline MPM AP Hie any help would be greatly appreciated
Electronics Forum | Mon Jul 06 07:06:44 EDT 2020 | dvetra
Hello! I am looking for documentation for the Speedline MPM AP HiE Screen Printer. Thanks! Dmitry
Electronics Forum | Mon Mar 15 10:36:06 EDT 2021 | richardcargill
We have an older MPM AP-B printer with a fault that requires expert attention. Does anyone know who I can contact regarding service/ repair in the UK? Thanks
Electronics Forum | Wed Apr 30 16:00:12 EDT 2008 | tech13108
Hello, We have recently purchased an older MPM via auction and I am trying to get it running but not getting too far. When I power it up it goes thru a boot sequence then a screen appears on the monitor with a "warning cover not closed, close cov
Electronics Forum | Wed Dec 13 16:40:40 EST 2000 | Bill Fluegel
I am receiving a "cognex not found" error upon bootup of a MPM AP24-X stencil printer. I have checked everything I can find between the cognex computer and the one in the machine. Has anyone experienced this before? Any ideas would be greatly appr
Electronics Forum | Fri Oct 29 15:29:56 EDT 2004 | jasont
Hi Ran, Have you considered 2nd hand screen printers? We are an SMT equipment re-seller but also operate a subsidary CM factory in SuZhou, China . We use Dek 265 LT and MPM AP screen printers in our SuZhou factory and have the following in stock f
Electronics Forum | Wed Jul 21 01:27:17 EDT 2004 | simmcircuits
Hi, I need help in aligning the stencil and the board on an MPM AP25. I have no calib jig and stencil what I did was edit w/dos editor the file ap.cal. It seems to be working OK now just a little bit of offset but what I'm concerned is the software t
Electronics Forum | Tue Jun 01 00:21:11 EDT 1999 | Lance Smalley
After lots of years with Panasert machines, I am starting to need to learn again. 1. For the AP-20 can you retrofit 3D vision? Would you bother? 2. Also for the AP, can you use 20x20 DEK screens with an adapter? Thanks to all you MPM experts. Lance