Electronics Forum | Tue Apr 01 16:14:37 EDT 2014 | emeto
Hello, I have newer generation machine(MV-7) and in my software I can open two programs at the same time. After you do that there is a button in the software saying T/B. when you press this button it will run board1(or top side) and right after you
Electronics Forum | Fri Apr 04 21:16:56 EDT 2014 | padawanlinuxero
Same option is in the MV-2 Open both programs and then run one of them after inspection turn the board and press start it would change to the other program with no problem.
Electronics Forum | Tue Jan 20 16:41:36 EST 2015 | royjulius
I have been reading an old Mirtec thread and in it a couple of guys mentioned that they have issues with their side view camera(s). I too have an issue with my east camera turning green at times. I'm not sure which channels our machine techs went thr
Electronics Forum | Wed Jan 19 12:54:17 EST 2011 | bdamico
Hello Mark, The centroid data you are currently using to program the MV-2HTL may be used with either platform. However, the libraries cannot be shared due differences in camera resolution. The MV-2HTL will have a 1.3 megapixel camera versus the 2 m
Electronics Forum | Fri Oct 12 01:50:51 EDT 2018 | robl
We have a pair of old 22XDL's that are just used for heritage boards, and they do a good job. They have 5MP cameras in them same as the MV3L's. We had MV3Ls and MV5's at a previous place and got similar results. The key is understanding properly h
Electronics Forum | Tue Nov 06 08:26:54 EST 2018 | bandjwet
We are considering a tabletop AOI primarily for rework purposes. In 95% of the cases we would NOT have centroid data NOR Gerbers, The area we would inspect would be in and around the BGA, QFN or LGA being replaced. In addition we would want o inspe
Electronics Forum | Mon Apr 12 12:11:18 EDT 2021 | Martin
Hello, we are on same boat. Our company looking for AOI system too. We also have Mirtec MV3-L. We are fine with it but we want in-line aoi because of automatisation. And primary in aoi specification we are looking for much more automatic learning
Electronics Forum | Mon Jan 10 18:35:05 EST 2011 | eadthem
Ive used a Mirtec machine for 3 years MV3L with side angle inspection. Mirtec has some issues documentation, and repair plus. But there machine is impressive and the AOI software is good. We can find about 90-99.99% of all errors using just the 5
Electronics Forum | Thu Apr 27 17:28:00 EDT 2017 | methos1979
At the time we purchased our MV-3L our smallest component was the 0805 so we got the 5 megapixel down camera although I don't remember the resolution but it was not the most fine one they had. We've since added 0604 components and solder evaluation i
Electronics Forum | Fri Nov 05 18:47:31 EDT 2010 | eadthem
I'm guessing when you say bare board you mean wet paste only? When you say the pads move slightly are your boards warped at all at the Vscore? What we do is use per modual fids. first you delete or don't make panel fids and then theres a option wh
